Insert/Remove Battery; Check The State Of Charge Of The Battery; Charge Battery - FLORABEST FAHE 18 A1 Betriebsanleitung

Charge the battery in a dry
room only. Prior to attach-
ing the charger, check that
the battery's outer surface is
clean and dry. There is a risk
of injury due to electric shock.
Only use the charger from the pack-
age to charge the battery. Mind not
to charge the appliance for more
than 1 hour at a time. If you do,
the battery and the appliance may
be damaged and longer charging
times would be a waste of energy.
Excessive charging will void the
warranty.
• Charge the battery before the first time
of use. Do not briefly charge the bat-
tery several time in a row.
• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to
be replaced. Only use an OEM spare
battery available from our Customer
Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information.
• The warranty excludes all defects
caused by improper handling.

Insert/remove battery

1. To insert the battery (11) into the
device, push the battery along
the guide rail (28) into the de-
vice. It locks into place audibly.
2. To remove the battery (11) from
the device, press the release but-
ton (11a) on the battery and pull
the battery out.
Check the state of charge of
the battery
The state of charge display (11b) signalis-
es the state of charge of the battery (11).
1. Press the button (11c) on the bat-
tery (11).
The state of charge of the battery
is displayed by illuminating the
appropriate LED lights of the
state of charge display (11b).
2. Charge the battery if the last LED
light of state of charge display
(11b) changes from green to red.

Charge battery

Allow a freshly charged battery
(11) to cool down for approx. 15
minutes before inserting it into the
battery charger (22).
LED lights:
• The control display (22a) of the battery
charger (22)
- lights up red at the start and during the
charging process.
- lights up green when charging process
is complete or if the battery cannot be
charged.
• The LED lights of the state of charge
display ( 11b) of the battery (11)
flashes red if you have inserted a hot
battery into the battery charger (22).
1. Remove the battery (11) from the
appliance, as necessary.
2. Insert the battery (11) in the
charging compartment of the
battery charger (22). It will audi-
bly snap in.
3. Plug the battery charger (22) into
GB IE CY
17