Maintenance And Cleaning - Oase Aquarius Universal Classic 440 Gebrauchsanleitung

- EN -
Start-up
Attention! The pump must never run dry.
Possible consequence: The pump will be destroyed.
Protective measure: Check the water level at regular intervals. Always
place the unit below water level.
How to operate the unit:
Install the pump ensuring that it is completely submerged. Allow the air in the
pump to fully escape. Ensure that the maximum permissible immersion depth of 1
m is not exceeded.
The required delivery volume can be set at the control lever:
To set the maximum delivery volume, slide the control lever fully to the left, in the
„+" direction.
To reduce the delivery volume, slide the control lever to the right, in the „–" direc-
tion.
This is how to connect the power supply:
Switching on: Connect the unit to the mains. The unit switches on as soon as the
power connection is established.
Switching off: Disconnect the unit from the mains.

Maintenance and cleaning

Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
Protective measures:
Electrical units and installations with a rated voltage of U > 12 V AC or
U >30 V DC located in the water: Isolate the units and installations
(switch off and disconnect from the power supply) before reaching into
the water.
Isolate the unit before starting any work.
Secure the unit to prevent unintentional switching on.
Attention! Risk of injury due to unexpected start-up.
The temperature monitor switches the unit off automatically in the event of
overload. The unit is switched on again automatically as soon as it has
cooled down.
Possible consequences: Risk of injury due to fast rotating components.
Protective measures: Always isolate the unit (switch off and disconnect
from the power supply) before starting any work on the unit.
12