Operation - AL-KO BKS 4040 Betriebsanleitung

en

OPERATION

36
STARTING ENGINE
1 Untwist and remove the fuel cap and oil cap. Rest the cap on a
dustless place.
2 Put fuel into the fuel tank and fill the chain oil into the oil tank to
80% of the full capacity.
3 Fasten the fuel cap and oil cap securely and wipe up any fuel
spillage around the unit.
4 Put the switch to the "I" position.
5 Continuously push the primer bulb until fuel comes in the bulb
(1) Oil
(2) Fuel
(3) Engine switch
6 Pull out the choke knob. The choke will close and the throttle
lever will then be set in the starting position.
When restarting immediately after stopping the engine. Set
choke in the open position.
Once the choke knob has been pulled out, it will not return to
the running position even if you press the throttle trigger or press
down on knob with your finger. When you wish to return the
choke knob to the running position, press the throttle trigger ins-
tead.
1 Push the front handle guard down toward the front to activate the
chain brake.
1 While holding the saw unit securely on the ground, pull the starter
rope vigorously.
1 When firing occur, press the throttle trigger to allow the choke return
to the running position and pull the starter handle again to start the
engine.
2 Pull up the front handle guard toward the front handle to release
brake. Then, allow the engine to warm up with the trigger pulled
slightly.
(4) Primer bulb
(5) Choke knob
BKS 3835 / BKS 4040
Operation