GUTMANN Adelante Bedienungsanleitung Seite 21

Exchange of the lighting
Please cut the connection between the
extractor hood and the power supply system!
For the exchange of the neon lamp the cover
of the lighting is to remove by a screwdriver.
The two screws are inside the hood body on
the left and right side of the lighting carrier.
Neon lamp or starter can be exchanged (see
picture). Taking out of the neon lamp is only
possible if the fluorescent lamp
is turned at 90 degree before.
is made in reverse order.
For the exchange of the halogen light remove
the glass cover carefully with a small
screwdriver, pull out the lamp and put in a
new one. At the same time please prevent
the direct contact between light bulb and
finger or fat.
Replace faulty lights through new ones
immediately.
The installation
Dysfunctions
Please refer to our customer service if
- the extractor hood produces too much
undefined noise and the control of the
exhaust air path reveils no faults;
- the supercharger works faulty;
- the circuit operates invalid.
Please indicate your type of extractor hood
and the serial number. These informations
are mentioned on the type sheet which is
situated inside the hood on the filter.
en