Installation Instructions - GUTMANN Llano Montageanleitung

en
Gas cookers
Comply with the currently valid installation
regulations and instructions of the gas
appliance manufacturers. The extractor hood
may only be installed over gas hobs at a
minimum distance of 650 mm provided the
following nominal thermal loads (Hs) are not
exceeded:
Gas cookers
Load of one hotplate max.
Load of all hotplates max.
Load of the oven
Gas hobs
Load of one hotplate max.
Load of all hotplates

Installation instructions

1 = Hood body
2 = Exhaust air connection
3 = Electrical connection
4 = Variable cupboard fixture
5 = Hole for ceiling mounting
1. (For extraction mode) Prepare a suitable
exhaust air guide in the ceiling.
3.0 kW
8.3 kW
max. 3.9 kW
3.9 kW
max. 11.3 kW
2. Specify the operator side of the hood on
the side having the LED power display, or that
is the operator panel.
3. Make a cut-out in for the hood in the fitted
cupboard. Take measurements of hood.
Make sure that the hood is positioned
centrally above the hob.
4. Insert the hood into the cut-out hole from
below until the bottom edge of the hood has
circumferential contact with the cupboard.
5. Now loosen the lateral cupboard fixtures
and adjust the corresponding installation
dimensions.