Troubleshooting - Braun ActivScan 9-SERIES Bedienungsanleitung

Troubleshooting

Problem
Device does not turn on,
ERROR BLUETOOTH
screen is black
ERROR BLUETOOTH
ERROR BLUETOOTH
ERROR BLUETOOTH
ERROR 0
ERROR BLUETOOTH
ERROR 0
ERROR BLUETOOTH
ERROR 0
ERROR BLUETOOTH
ERROR 0
ERROR BLUETOOTH
ERROR BLUETOOTH
ERROR BLUETOOTH
ERROR 1
ERROR 0
ERROR 1
ERROR 0
ERROR 1
ERROR 0
ERROR 1
ERROR 0
ERROR 0
ERROR 0
ERROR 2
ERROR 1
ERROR 2
ERROR 1
ERROR 2
ERROR 1
ERROR 2
ERROR 1
ERROR 1
ERROR 1
ERROR 3
ERROR 2
ERROR 3
ERROR 2
ERROR 3
ERROR 2
ERROR 3
ERROR 2
ERROR 2
ERROR 2
ERROR 255
ERROR 3
ERROR 255
ERROR 3
ERROR 255
ERROR 3
ERROR 255
ERROR 3
ERROR 3
ERROR 3
ERROR 254
ERROR 255
ERROR 254
ERROR 255
ERROR 254
ERROR 255
ERROR 254
ERROR 255
ERROR 255
ERROR 255
ERROR FIRMWARE
ERROR 254
ERROR FIRMWARE
ERROR 254
ERROR FIRMWARE
ERROR 254
ERROR FIRMWARE
ERROR 254
ERROR 254
ERROR 254
ERROR FIRMWARE
ERROR FIRMWARE
ERROR FIRMWARE
ERROR FIRMWARE
ERROR FIRMWARE
ERROR FIRMWARE
Reason
Low battery warning
Empty battery warning
Problem with batteries
Cannot connect to
Smartphone
Measuring error
Pumping error
Out of Range Results Error
Pump time error
Device internal error
Calibration error
An error occurred during
the Bluetooth Firmware
update
Solution
Batteries are low. Be ready to replace batteries with new ones
soon.
Indicates that batteries are completely discharged. Insert new
batteries or check that batteries are correctly inserted.
Change batteries for new ones and make sure to insert them
correctly. If problem persists, contact consumer support.
Stay away from radio interference like microwave ovens, WiFi
routers, laptop computers, etc... Make sure Bluetooth is enabled
on your Smartphone before starting the pairing sequence.
Follow the instructions for Bluetooth pairing in the Braun
APP and re-initiate the Bluetooth pairing sequence using the
Braun APP.
The pulse signals on the cuff are too weak. Re-position the cuff
and repeat the measurement.
The cuff is not fastened properly. Re-position the cuff and
repeat the measurement.
Relax for a while and repeat the measurement. Make sure the
cuff is correctly positioned on your arm.
The cuff is not fastened properly. Re-fit the cuff, and take a
measurement again.
Remove and then reinsert the batteries. If the problem persists,
contact customer support.
Remove and then reinsert the batteries. If the problem persists,
contact customer support.
Device will automatically restart using the original Bluetooth
firmware. Re-initiate the firmware download process or follow
the on-screen instruction from Braun APP.
English
11