Tyco R/C Suzuki GSX-R 1000 Bedienungsanleitung Seite 3

Keep these instructions for future make sure you ALWAYS operate your
reference: they contain important vehicle in a large open space, like a
information. playground. NEVER drive your vehicle toward
people, animals or fragile objects!
XCAUTION: Surfaces may become hot and
* Your vehicle is a racing-style R/C
cause burns if electronics get wet. Do not motorcycle, engineered for operation on
operate vehicle through water or snow. smooth, hard surfaces – like
pavement or asphalt. NEVER drive your
vehicle on any other kind of
I. CONTENTS/FEATURES
surface.
• Vehicle
A. Skid Plates
• Transmitter
When you're learning how to drive your
• Skid Plates (shown unattached)
vehicle, you may find that you have more
X Please see the "Vehicle Operation" Section
success when the special skid plates are
for more information.
attached. The skid plates attach to the bottom of
• Launcher/Display Stand
the vehicle as shown.
X Please see the "Vehicle Operation" Section
NOTE: You will need to remove the Skid Plates in
for more information.
order to access the vehicle's Battery Door.
• 7.2V NiCd Battery Pack
• 7.2V NiCd Wall Charger
Steering
• 4 AA Alkaline Batteries (for vehicle)
With the skid plates attached, you can launch
• 4 AA Zinc-Oxide Batteries
your vehicle from a standing start (with the
(for transmitter)
vehicle resting on one of the skid plates).
• Telescoping Antenna
Simply pull the transmitter's trigger to drive
• 2 Skid Plate Screws
forward, using the steering control as
necessary to drive in a straight line as
you accelerate.
VEHICLE
q Battery Door
B. Launching Your Vehicle
(a) Rechargeable battery compartment
For a "pro" racing start, use the
(7.2V NiCd).
included Launcher/Display Stand as shown:
(b) Interior battery compartment
(a) Place the launcher on a smooth, flat
(4 AA alkaline batteries)
driving surface.
(c) Wire connector for 7.2V
(b) Place the vehicle onto the launcher as shown.
w TRY-ME Button (on knee)
(c) Stand on the launcher as shown.
e ON/OFF/LIGHT & SOUND Switch
The launcher will lift the vehicle's rear tire off
* This switch has 3 positions:
the ground.
(d) Pull the transmitter's trigger to
I = ON -This is the normal driving
activate the vehicle's drive motor. Hold the
position for your vehicle
O trigger to let the rear
= OFF
wheel spin up to speed.
/ = DISPLAY - To activate lights and sound,
(e) Keep holding the trigger as you lift your foot
press the TRY-ME
from the launcher, the vehicle will drop onto
button on the rider's knee
the ground and hit the ground running!
r MultiBand™ Selector Switch
* Please see the "MultiBand™ Feature" Section
III. ADVANCED OPERATION
for more information.
A. Braking Systems
TRANSMITTER
Your vehicle is engineered with two advanced
q Trigger: Throttle/Braking Control
braking systems for maximum performance:
w Steering Control
e "Turbo" Button
1. When you release the transmitter's
r "REV-UP" Button
trigger while driving, the vehicle will coast to a
t LED Indicator
gradual stop.
y Telescoping Antenna
(extend fully for operation)
2. For a quicker stop, push the
6.1 Before operating your vehicle for the first
transmitter's trigger forward. Your
time, carefully screw the antenna into the
vehicle will come to a stop almost
transmitter. Make sure the antenna is fully
immediately.
extended before operating.
u MultiBand™ Selector Switch
B. "Turbo" Boost
After 3+ seconds of driving you can push and
* Please see the "MultiBand™ Feature"
hold down the turbo button for an extra burst of
Section for more
speed.
information.
C. "Rev-up" Button
i ON/OFF Switch
You can push the sound button any time, while
driving, to activate the vehicle's cool sound fea-
II. BASIC OPERATION
ture.
D. Driving Tip
You'll want to take a little time to
For tighter turns, pulse the trigger as you're
familiarize yourself with your vehicle's
heading into a turn.
features and controls. With practice, you'll
be a "pro" driver before you know it.
E. Display Stand
Turn the Launcher over to convert it to a
• Forward
display stand for your vehicle. Place the
• Braking
vehicle onto the display stand as shown.
• Steering
• "Turbo" Boost
MULTIBAND™ FEATURE
• Sounds
• Your vehicle features the advanced Tyco® R/C
* Your vehicle's light and sound features will
MultiBand™ system. This system lets you race
activate automatically as you drive –
your vehicle head-to-head – against up to 3 of
for ultimate realistic driving action!
your friends (up to 4
drivers total) – without any radio
* Your vehicle is an ultra-high-performance,
interference problems.
high-speed vehicle, designed exclusively
• There's one MultiBand™ Selector Switch on
for outdoor driving. For best driving results,
your vehicle chassis, and another one on your
4
h
transmitter. The vehicle switch has 4 positions:
one for each MultiBand™ setting.
4 3 2 1
The transmitter switch also has 4 positions: one
for each MultiBand™ setting.
1 2 3 4
• For successful operation, the vehicle switch
and the transmitter switch must be set to the
same MultiBand™ setting. When you're driving
by yourself, you can set the switches to any of
the 4 MultiBand™ settings (as long as they
match).
• When you want to race with other RC
vehicles, just make sure each driver is
tuned to a different Multiband setting.
• To operate your vehicle, just turn the vehicle
ON. Push any transmitter
control and you will be able to run and
control your vehicle.
* A non-MultiBand™ vehicle, running on the
same frequency as your vehicle, may interfere
with operation of your vehicle. If you are rac-
ing against a non-MultiBand™ vehicle, make
sure that vehicle operates on a frequency dif-
ferent from yours.
* If you need to change the MultiBand™
setting, first make sure that your
vehicle is turned OFF. Change the switch
position as desired, making sure to change
both the transmitter AND the vehicle
switches. Then turn your vehicle back ON for
more racing action. NOTE: Make certain
you're not pressing a transmitter control while
changing selector switch position.
IV. VEHICLE BATTERY INSTALLATION
Your vehicle uses two different power sources: 4
AA alkaline batteries PLUS a 7.2V NiCd recharge-
able battery pack. For detailed information
regarding rechargeable battery charging and
safety, please refer to the Battery
"Charging/Care" Section.
A. To install the 4 AA alkaline batteries:
1. Rotate the battery door latch to unlocked posi-
tion and open the battery door.
2. Use a screwdriver (not included) to open the
interior battery door.
3. Install 4 AA alkaline batteries in the interior
battery compartment, with polarity (+/-) as
shown inside battery compartment.
4. Replace the interior battery door and
tighten the screw.
B. To install the 7.2V NiCd battery pack:
1. Insert the charged battery pack into the bat-
tery compartment as shown.
2. Connect the battery pack's wire connector to
the vehicle's wire connector as shown. Make
certain the connectors are securely snapped
together.
3. Close the battery door and rotate the
battery door latch to locked position.
* The 4 AA alkaline batteries will last much
longer than the running time of the charged
7.2V NiCd battery pack. When the vehicle
stops, the headlights blink, and you hear a
beep every two seconds--you should recharge
the 7.2V NiCd battery pack. When you hear a
double-beep--change the 4 AA alkaline
batteries.
C.TRANSMITTER BATTERY INSTALLATION
1. To install transmitter batteries, open battery
door as shown.
2. Install 4 AA batteries, with polarity (+/-) as
shown inside battery compartment.
3. Replace battery door.
* If the transmitter's LED indicator does not light
Note to Adults:
when the transmitter is switched ON, it's time
• Remove rechargeable batteries before recharg-
to replace the transmitter batteries. Simply
ing. The battery charger should be operated
install fresh batteries as described above.
only under adult supervision.
• Regularly examine for damage to the plug,
V. BATTERY CHARGING/CARE
enclosure and other parts. In the event of any
damage, the toy must not be used with the
X CAUTION: Use only the charger supplied with
transformer until the damage has been
this toy. Do not use any other
repaired.
charging source.
• This toy is not intended for children under 3
years old. The battery charger is not a toy.
Use only Tyco® R/C 7.2V NiCd battery packs.
THIS PRODUCT USES A NICKEL-CADMIUM
Other batteries may leak or rupture, causing
RECHARGEABLE BATTERY PACK.
personal injury and damage.
BATTERY MUST BE RECYCLED OR
DISPOSED OF PROPERLY. FOR FURTHER
1. Plug wall pack charger into standard wall
INFORMATION REGARDING BATTERIES OR
outlet.
THEIR DISPOSAL PLEASE CONTACT THE
2. Connect the battery pack's wire connector to
APPROPRIATE LOCAL OFFICE.
the wall pack charger connector. Make certain
the two connectors are tightly snapped
together.
; VI. QUICK TIPS
3. To disconnect wires, push down on the
connector clip and pull apart.
1. When your vehicle starts to lose power, it may
4. After charging, the battery will feel warm. This
lose functions or performance. It's time for a
condition is normal for fully charged batteries.
recharge. For best stunt performance, always
5. New battery packs must be charged for 5 1/2
start with a fully-charged battery.
hours the first two times charged. Subsequent
2. Your vehicle's running time may change
charges will require 4 hours. Charging the bat-
depending on your driving style.
tery pack for more than 5 1/2 hours will not
3. Radio interference can make your vehicle run
give you a longer running time. 5 1/2 hours is
badly. Interference can be caused by other R/C
all that is required for a fully charged battery
vehicles running on the same frequency; elec-
pack.
trical wires; large buildings; CB radios; or other
6. Unlike alkaline batteries, which lose power
wireless gear. Try to stay away from these!
gradually, a NiCd (Nickel-Cadmium) battery will
4. Extend your antenna and point your transmitter
run for its normal running time and then lose
antenna up - not down toward your
most of its power at once. It is time to
vehicle. If your vehicle gets too
recharge the battery pack.
far away, it won't work properly.
7. After use, the battery pack will be hot! Wait at
5. Don't drive your vehicle in sand or through
least 20 minutes until the battery pack cools
water or snow. If your vehicle does get wet,
before recharging. Recharging a warm or hot
wipe with a towel and allow to dry completely.
battery pack will greatly reduce the number of
6. Don't store your vehicle near heat or in direct
times your battery pack can be recharged.
sunlight. Always turn switches OFF and
remove all batteries for storage.
RECHARGEABLE BATTERY
INFORMATION:
VII. CONSUMER INFORMATION
• DO NOT RECHARGE BATTERY PACK IF IT'S HOT.
ALLOW IT TO COOL BEFORE RECHARGING. Note to Adults: To ensure that the child's play is
• DO NOT RECHARGE A BATTERY PACK THAT both safe and fun, please review all operating
SHOWS LEAKAGE OR CORROSION. instructions and safety rules with your child.
• DO NOT DISASSEMBLE THE BATTERY PACK.
THE BATTERY PACK IS A SEALED RECHARGE- SAFETY TIPS
ABLE NICKEL-CADMIUM BATTERY PACK.
• NEVER drive your vehicle on streets! They're
• EXERCISE CAUTION IN HANDLING A HOT
for real cars!
BATTERY PACK.
• DO NOT pick up vehicle while in motion.
• IF BATTERY PACK AND/OR CHARGER ARE
• Keep fingers, hair and loose clothing away from
WET,THOROUGHLY DRY BEFORE
the tires and the wheel hubs while the vehicle
CHARGING.
is switched ON.
• DO NOT RECHARGE NON-
RECHARGEABLE BATTERIES. XCAUTION: To prevent entanglement, keep hair
away from wheels.
TROUBLESHOOTING: PROBLEM? - SOLUTIONS
SYMPTOM PROBABLE CAUSE
Vehicle runs slowly or will not run. • Loose battery connection or switches not ON.
• Weak or uncharged rechargeable NiCd battery.
• Weak transmitter battery.
Erratic operation or only short range possible. • Radio interference likely.
• Antenna snapped into carry-loop holder.
Short rechargeable NiCd battery life. • Battery not fully charged.
Vehicle doesn't work after going through water • Water in the electronics area.
or snow.
5
h
• Adult supervision is recommended when this
vehicle is being operated.
• To avoid accidental operation, remove all
batteries when not in use. Always turn the
vehicle OFF before removing batteries.
• Regularly inspect the antenna for cracks or
breaks. Do NOT bend the transmitter antenna
when extended. DO NOT use the transmitter if
the antenna is broken.
BATTERY SAFETY INFORMATION
In exceptional circumstances batteries may leak
fluids that can cause a chemical burn injury or
ruin your toy (product). To avoid battery leakage:
• Non-rechargeable batteries are not to be
recharged.
• Rechargeable batteries are to be removed from
the toy before being charged (if designed to be
removable).
• Rechargeable batteries are only to be charged
under adult supervision (if designed to be
removable).
• Do not mix alkaline, standard (carbon-zinc),
or rechargeable (nickel-cadmium) batteries.
• Do not mix old and new batteries.
• Only batteries of the same or equivalent type as
recommended are to be used.
• Batteries are to be inserted with the correct
polarity.
• Exhausted batteries are to be removed from
the toy.
• The supply terminals are not to be short-circuited.
• Dispose of battery(ies) safely.
• Do not dispose of this toy in a fire. The batteries
inside may explode or leak.
Battery Performance Note:
For best performance use regular or
high-performance alkaline batteries (where
disposable batteries are called for). If your
vehicle is supplied with standard (carbon-zinc)
batteries for initial use and/or demonstration
purposes, we recommend replacing them with
alkaline batteries when necessary. Battery life
may vary depending on battery brand.
XCAUTION! Only allow children at least 8 years
old to use the battery charger. The
battery charger is not a toy and should be
used only under adult supervision.
CORRECTION
• Check battery connector and switches.
• Charge battery or replace.
• Replace with fresh alkaline battery.
• Change location (see point 2 – Quick Tips).
• Make sure antenna is fully extended.
• Recharge vehicle battery.
• Vehicle will take several hours to dry. Allow to
dry thoroughly overnight before trying again.
• Operate your vehicle in a dry area. Avoid driving
in water and snow.