Sage the Barista Express Kurzanleitung Seite 21

PROBLEM POSSIBLE CAUSE
Machine is on
• The safety thermal-cut out may have
but ceases activated due to the pump or grinder
to operate.
overheating.
No ground
• No coffee beans in hopper.
coffee coming
from grinder.
• Blocked grinder chamber or chute.
• Water / moisture in grinder chamber
and chute.
FILTER SIZE
• Bean hopper is not attached correctly.
LED's are
flashing.
Too much/ • Grind amount settings are incorrect
too little
for particular grind size.
ground coffee
is being
delivered
to the filter
basket.
Too much/too
• Grind amount and/or grind size
little espresso
settings and/or shot volumes
is being
require adjustment.
delivered to
the cup.
Grinder • Blockage or foreign object in grinder.
is making
a loud noise.
WHAT TO DO
• Press the POWER button to switch the machine off
and unplug from the power outlet. Allow to cool for
about 30–60 minutes.
• If problem persists, call Sage Customer Service on:
0808 178 1650.
• Filler hopper with fresh coffee beans.
• Clean and clear grinder chamber and chute.
Refer to 'Advanced Cleaning for the Conical Burr
Grinder', page 16.
• Clean and clear grinder chamber and chute. Refer
to 'Advanced Cleaning for the Conical Burr Grinder',
page16. Ensure burrs are thoroughly dry before
re-assembling. It is possible to use a hair
dryer to blow air into the grinder chamber.
• Remove hopper, check for debris and then re-lock
hopper into position.
• Use the GRIND AMOUNT dial to increase or
decrease the grind amount. Refer to 'Setting the
Grind Amount', page 9 and 'Extraction Guide',
page 11.
• Try the following, one at a time:
• Reset the machine to its original default settings.
Refer to 'Resetting Default Volumes', page 10.
• Re-programme the shot volumes. Refer to
'Re-Programming Shot Volume', page 10.
• Adjust the grind amount and/or grind size settings.
Refer to 'Setting the Grind Size', page 9, 'Setting
the Grind Amount', page 9 and 'Extraction Guide',
page 11.
• Remove hopper, check for debris or blockage.
If necessary, clean and clear grinder chamber and
chute. Refer to 'Cleaning the Conical Burr Grinder',
page 16.
EN
21