Installation; Upright Assembly; Wall Mounting - Silvercrest SKT 2000 B1 Bedienungsanleitung

Installation

GB

Upright assembly

Wall mounting

28
CAUTION
► During assembly, lay the appliance on a soft surface, e.g. on a carpet, to
avoid any damage.
♦ Place the appliance on a soft surface with the base uppermost.
♦ Attach the two feet
supplied. Each foot should be fitted with 2 screws, which are screwed in
diagonally.
WARNING! RISK OF INJURY BY ELECTROCUTION!
► When drilling the holes, ensure that no electric cables or other wall installa-
tions, such as water pipes, are damaged.
► The supplied wall plugs
stone. Before starting the installation, please check your installation loca-
tion carefully for its suitability for the wall plugs
professional.
NOTE
► When selecting the mounting location make sure that a suitable mains wall
socket is located within the plug-in radius of the mains power cord.
► If you are mounting the heater on the wall, the feet
♦ Mark two drill holes at a minimum height of 435 mm and at a distance of
391 mm (see Fig. drill diagram).
♦ Now bore the two holes to a minimum depth of 40 mm using an electric or
hand drill fitted with a 8 mm drill bit.
min. 435 mm
Fig. drilling diagram
3 to the bottom of the appliance using the short screws
are only suitable for mounting on concrete or
15
391 mm
. If in doubt, consult a
15
3 should not be fitted.
ø 8 mm, 40 mm
SKT 2000 B1