Temperature Selector; Cleaning And Maintenance - SOLAC RA8019 Gebrauchsanleitung

– Position I – Medium temperature - MED
– Position II – Maximum temperature - MAX
• The power for the various levels, MED (W), MAX (W), is shown in Table 1.
• To disconnect the appliance, turn the power selector to the position 0 and
pull the plug out of the socket.

1.2 TEMPERATURE SELECTOR

• Turn the temperature selector (3) clockwise as far as it will go. When the
room reaches the desired temperature, slowly turn the selector anticlockwise
until the pilot light (5) goes out. You can leave the selector in this position.
When the room temperature drops below the level marked on the thermo-
stat, the radiator will come on automatically until the desired temperature
is reached. In this way, the room temperature is always kept at the same
level, with minimum electricity consumption.

CLEANING AND MAINTENANCE

• Make sure the radiator is not connected to the mains, and let its surface
cool if you were using it previously.
• The electric oil radiator does not require special maintenance for its numer-
ous uses. Use a damp, soft cloth to clean the radiator. Do not use solvents
or abrasive detergents. When necessary, use a vacuum cleaner to remove
the dust from the radiator.
• After each season, roll the cable around the cable winder (12) and store the
radiator in a dry place.
TABLE 1
MODEL
RA8017
RA8019
RA8021
10
Radiador RA8021-19-17-OK 10
MED (W)
900
1200
1500
MAX (W)
1500
2000
2500
12/5/06, 10:59:16