Siemens SIMATIC HMI Kompaktbedienanleitung Seite 17

3.3 Changing network and connection parameters of a controller
3.3.1 Opening the 'IP Adaptation' dialog
Expansions with WinCC V12 (TIA Portal)
A5E32030248-AB, 07/2013
1. Click the "Service & Commissioning" button in the
Control Panel.
2. Switch to the "IP Adaptation" tab and open the
"Info" dialog with the "Next" button.
3. Make sure you read the text in the "Info" dialog
referring to the configuration in the TIA Portal.
Open the "IP Adaptation" dialog with the "OK"
button.
The following options are available in the "IP
Adaptation" dialog:
● You can look for accessible controllers with
"Accessible devices" and then change the IP
address of a controller. Continue in chapter
"Finding controllers and changing network
parameters (Page 18)".
● Use "Override projected information" to change
the existing configured connection parameters of
a controller. Continue in chapter "Changing
configured connection parameters (Page 20)".
● Click the "Cancel" button to return to the Control
Panel.
17