Operational Elements - Conrad 18 76 33 Bedienungsanleitung

Please observe the other safety instructions in the individual chapters of this opera-
ting manual.
Should you have any questions that have not been answered in the operating
manual, please contact our Technical Hotline or any other specialist.
Labelling Laser class 3A (Laser Module
3 mW):
The product is equipped with a laser class 3A according to EN 60 825-1: 1997.
Fasten labels close to the laser output.
Labelling Laser class 3B (Laser module
10 mW):
The product is equipped with a laser class 3B according to EN 60 825-1: 1997.
Fasten labels close to the laser output.
14
Taking the laser into operation
In order to make sure that the device is properly taken into opera-
tion, please read the operating manual with the safety instructions
completely and carefully before use.
Additional protective measures for a safe operation
Since this is a laser module, and the final product cannot be influence by the manu-
facturer of the laser module, we can only refer to the relevant standard and regulati-
on.
In the annex you can find addresses where to get relevant information material.
The final product must fulfil the legal requirements in any case and must be
classified accordingly.

Operational elements

(1) Control socket
(2) Key switch
(3) Mains cable
(4) On-Off switch
(5) Laser outlet
(6) Shutter
15