Temperature Control And Adjustment; Before Operating; Freezer Control Panel - Beko FS 220N Bedienungsanleitung

EN

Temperature control and adjustment

The freezer temperature is influenced by the
Freezer Set Function (position 1, Fig. 5).
Generally, this temperature is bellow -18°C.
Lower temperatures can be obtained by
adjusting the Freezer Set Function towards
coldest position.
We recommend checking the temperature
with a thermometer to ensure that the storage
compartments are kept to the desired
temperature. Remember to take the reading
immediately since the thermometer
temperature will rise very rapidly after you
remove it from the freezer.
Please remember that each time the door is
opened cold air escapes and the internal
temperature rises. Therefore never leave the
door open and ensure it is closed immediately
after food is put in or removed.

Before operating

Final Check
Before you start using the freezer check that:
1. The feet have been adjusted for perfect
levelling.
2. The interior is dry and air can circulate
freely at the rear.
3. The interior is clean as recommended
under "CLEANING AND CARE."
4. The plug is inserted into the wall socket
and the electricity supply is switched on.
Avoid accidental disconnection by taping over
the switch.
And note that:
5. You will hear a noise as the compressor
starts up. The liquid and gases sealed within
the refrigeration system may also make some
noise, whether the compressor is running or
not. This is quite normal.
6. To freeze the fresh foods use the
compartment marked with 4 stars
(recomanded second shelf).
7. Don't put in freezer a too big quantity of
foods in the same time. The foods quality is
well kept if they are deeply frozen in the
shortest time possible. Therefore it is
preferable do not exceed the freezing capacity
of the appliance shown in "Appliance record".
The Freezer Set Function shall be adjusted in
order to obtain the lowest temperature inside
the freezer, with the fast freeze function
activated and the indicator lighting.
Instruction for use
8. Do not load the appliance immediately it is
switched on. Wait until the correct storage
temperature has been reached. We
recommend that you check the temperature
with an accurate thermometer (see;
Temperature Control and Adjustment).
Important Note:
If there is a power failure do not open the
door. Frozen food should not be affected if the
failure lasts for less than 15 hours. If the
failure is longer, then the food should be
checked and either eaten immediately or
cooked and then re-frozen.

Freezer control panel

(Fig. 5)
The control panel adjusts the temperature in
the freezer and has the following functions:
1 - Freezer Set Function
This function allows you to make the freezer
compartment temperature setting.
Press this button to set the temperature of the
freezer compartment to - (warmest), --, ---, ----
(coldest) respectively.
2 - Freezer Compartment
Temperature Setting Indicator
Indicates the temperature set for the Freezer
Compartment.
Settings are - (warmest), --, ---, ---- (coldest)
3 - High Temperature Error / Warning
Indicator
This light comes on during high temperature
failures and error warnings.
4 - Quick Freezer Indicator
This icon lits when the Quick Freezer function
is active.
5 - Quick Freezer Function
When you press Quick Freezer button, the
temperature of the compartment will be colder
than the adjusted values.
This function can be used for food placed in
the freezer compartment and required to be
frozen down rapidly. If you want to freeze
large amounts of fresh food, it is
recommended to activate this feature before
putting the food into the freezer.
Quick Freezer indicator will remain lit when
the Quick Freezer function is enabled.
To cancel this function press Quick Freezer
button again. Quick Freezer indicator will turn
off and return to its normal settings.
3