Usage Instructions; A/Model - Gps4 - Absaar AB100-1275 GPA7.5 Bedienungsanleitung

6-Usage instructions:

IMPORTANT
Always follow the procedure below to connect
a battery to a charger:
1- Connect the red (+) clamp to the positive termi-
nal of the battery
2- Connect the black (-) clamp to the negative ter-
minalof the battery.
3- Plug in the power cable

A/Model - GPS4.

IMPORTANT
The ABSAAR GPS4 charger is a STANDARD charger, which means it needs to be
disconnected manually once the battery is fully charged. Do not leave the char-
ger permanently connected to the battery as this could result in the battery being
destroyed.
1. 6 volts/12 volts switch
Red light indicates: Power indic ator
Red light indicates: Low battery load
Yellow light indicates: Medium battery
load
5. Green light indicates: Battery fully
charged
Charging the battery:
1- Select battery voltage - 6 volts or 12 volts – using the switch (1) and referring to the
indication on the battery (voltage displayed in volts).
2- Connect the battery to the charger following the connection procedure.
3- Kindly refer to the indicators below to understand the battery charging status:
• Red light indicates: Low battery load
• Yellow light indicates: Medium battery load
• Green light indicates: Battery fully charged
4- Disconnect the battery manually once it is fully charged.
1
Page 7
2 3 4
ENG
5
vers.3