Kaiser KA 3 Series Gebrauchsanweisung Seite 68

3
4
1
Simbol
number
2
5
68
Simbol
on
off
am
pm
EN
NOTE:
• This function is valid only on HEAT
or COOL mode.
• After the function of power run 15
minutes, it will be automatic exit.
Then it will run in the mode which
is set before the power function.
Screen display
setting
• Press the «POWER» for 3 sec-
onds, it will display the state of
the air conditioner through LED
LCD or VFD.
• Press it for 3seconds again, it will
cancel the screen display.
Button 1, TIMER/CLOCK
Setting the on/off timer time, when
remote controller is at the on/off state,
press this button 1, on the LCD fli-
ckers the symbol 2. Press the 3 or
4 button to set the timer time. After
finishing it, press this button again
in 10 seconds to affirm. If the setting
time is the same as the current time,
this setting is invalid. Press the but-
ton once more, The symbol disap-
pears, the function is cancelled at
the same time.
Adjusting the clock time
Press this button in 5 seconds under
the state of no timer setting, the LCD
flickers the 5, symbol. Press the 3
or 4 to set the timer time. After fini-
shing it, press this button again in 10
seconds to affirm. If not, this opera-
tion is invalid.
Button 4,
This button not only can adjust clock
time and the timer time but also can
set room humidity.