L) "Auto Entry" Mode (Automatic Code Recognition) - Renkforce 1582597 Bedienungsanleitung

l) "Auto Entry" mode (automatic code recognition)

• By default, the code lock is set to manual entry mode. In this mode, after you enter a user/
guest code, you need to confirm your entry with the # key (hash key). The master code does
not need to be the same length as the user codes. The codes can be 4–8 digits long – for
example, an 8-digit master code can be used with 5,4 or 3-digit user codes. Vice versa, you
can also use a 5-digit master code with an 8, 4 or 5-digit user code.
• In auto-entry mode, you do NOT need to press the # key (hash key) to confirm the entry of
a user/guest code. However, the user codes must have the same number of digits as the
master code. For example, you cannot set a 4-digit master code and a 6-digit user code. The
codes must be 4–8 digits long – if the master code is 8 digits, the user codes must also be 8
digits. Similarly, a 4-digit master code can only be used with 4-digit user codes.
Using a very short master code reduces the security of the system (longer codes are
more secure) as well as the number of user code combinations.
82 + 1 + # = Enable auto-entry mode
3 2 8 9
*
8 2
1 #
*
82 + 0 + # = Disable auto-entry mode
3 2 8 9
*
8 2
0
#
Enter the master code (in this example, the master code is "3289")
to enable programming mode, and then press the * key. The code lock
will beep twice and the yellow LED will stay constant to indicate that
programming mode is enabled.
Enter the memory code "82", and then press "1".
Press the # key to confirm your entry.
The code lock will beep and the yellow LED will flash twice, indicating that
auto-entry mode has been enabled.
Press the * key to exit programming mode. The yellow LED will start to
flash again.
The combination lock is now in auto-entry mode.
Enter the master code (in this example, the master code is "3289")
to enable programming mode, and then press the * key. The code lock
will beep twice and the yellow LED will stay constant to indicate that
programming mode is enabled.
Enter the memory code "82", and then press "0".
Press the # key to confirm your entry.
The code lock will beep and the yellow LED will flash twice, indicating that
auto-entry mode has been disabled.
67