Other Operating; Recording Audio Cd To A Usb Device - Pioneer MCS-838 Bedienungsanleitung

66

Other Operating

En
Chapter 7
Other Operating
Recording Audio CD to a
USB device
You can record audio CD to the rear USB device
using this player.
Caution
The USB port on the front of the unit cannot be
used for recording.
1. Insert an USB device into the USB port
on the rear panel.
2. Open the disc tray and place an Audio
CD on the tray.
Press
OPEN/CLOSE.
3. Close disc tray.
OPEN/CLOSE is pressed, playback
will start automatically.
If playback does not start automatically,
press the
(PLAY/PAUSE) on the device to start
playback.
4. Press USB REC during CD playback.
[CD RIP] will be displayed.
5. Select the song or the Track No. you
want to record.
If you are recording all the songs on the CD
use / / / to select [Select all] and press
7
ENTER.
If you are selecting a Track to record use
/ / / to select the Track No. and press
ENTER.
If there are more than one Track you want
to record, repeat the step for 5.
If you want to delete a selected Track use
/ / / to select [Select None] and
press ENTER.
PLAY on the remote or
6. Set the recording speed
Use / / / to select [Speed] and press
ENTER.
The recording speed will change each
time ENTER is pressed. The recording
speed will change as shown below.
Normal: when recording while listening
to the music.
Fast: will record at approx 4x speed. You
cannot listen to the music.
7. Start recording.
Use / / / to select [Start] and press
ENTER to start recording.
8. Exit CD recording display.
Use / / / to select [Cancel] then press
ENTER after recording has finished.
Note
Use cursor
ENTER to change the Bitrate setting.
The set speed will change each time [Bitrate] is
pressed. The set value can be selected from those
shown below.
[64kbps]
/
[256kbps]
created in the [Pioneer] folder on the unit's rear
USB device.
The maximum number of folders that can be
created is 100.
This unit does not support a USB hub.
/ / / to select [Bitrate] then press
[96kbps] [128kbps]
[320kbps]
[192kbps]