EWT NOCeco10LCD Handbuch Seite 6

Setting Programmes
Press the 'PROGRAM' key twice to set the programs.
You are now setting the programs starting with P1 'ON'.
SETTING P1 ON TIME:
1. To set the hour use the '-' & '+' buttons. Confirm the hour digit by pressing
'ENTER'.
2. To set the minutes use the '-' & '+' buttons. Confirm the minute digit by pressing
'ENTER'.
Note: The minutes can only be set in 10 minute blocks in programme 'MODE'.
SETTING P1 OFF TIME:
3. To set the hour use the '-' & '+' buttons. Confirm the hour digit by pressing
'ENTER'.
4. To set the minutes use the '-' & '+' buttons. Confirm the minute digit by pressing
'ENTER'.
Repeat steps 1 to 4 to programme P2, P3 & P4. After programming P4 'OFF' you
automatically exit to the default display.
At any time while programming the timer you can press the 'PROGRAM' button to
exit to the default display.
Note: If the 'ON' time is the same as the 'OFF' time the appliance will ignore the
program.
The Advance Function
When in 'AUTO' MODE, if the '+' button is pressed for longer than 2 seconds the
programme will ADVANCE to the next setting programmed and will only revert
back to the program when the subsequent programme time is reached. When the
'ADVANCE' function is running the 'ADVANCE' segment will be displayed on the
LCD screen. If the '-' button is pressed when the 'ADVANCE' programme is
running the 'ADVANCE' feature will be automatically cancelled and the programme
will run as normal.
Note - Timer Memory Back Up Batteries - Once the heater has been left plugged
in with the socket switched on for at least 72 hours the timer's memory back up
batteries will be fully charged.
Once the timer batteries are fully charged, if there is a power cut or if the heater
is disconnected from the mains for less than six months, then the timer will
continue to keep time & the settings in the memory will remain intact.
If however the timer back up batteries have not been charged fully, or if the
heater is deprived of power for longer than six months, then the time and the
programme settings are likely to be lost and you may therefore need to reset the
time and the programme before using the AUTO MODE again
Cable storage (see Fig. 1)
Cleaning
· Switch off the appliance first and disconnect the plug from the socket!
· Clean the housing with a moist cloth, vacuum cleaner or brush.
· Do not use any abrasive or caustic cleaning agents!
· Do not use any flammable cleaning agents e.g. petrol or spirit for cleaning the
appliance.
· Never immerse the appliance in water! Danger to life!
· Air inlet- and outlet area should be cleaned with a vacuum cleaner regularly.
· If the appliance is not used for extended periods, it must be protected against
excessive dust and dirt.
Recycling
For electrical products sold within the European Community.
At the end of the electrical products useful life it should not be
disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice
in your country.
After Sales Service
All repairs must be referred to authorised personnel!
See your local dealer.Any tampering with the appliance will invalidate the warranty.
Repairs carried out improperly and by unqualified persons may have serious
consequences for the user!
In the interests of further development, the appliance may be subject to
constructional or design changes without prior notice.
UK