D) Moving The Metal Detector When Searching For Objects; E) Isolating The Detected Object; Using Headphones - Renkforce MD 200 Bedienungsanleitung

• Due to these factors, it is important that you familiarize yourself with the metal detector and how it responds before
attempting to search for objects.

d) Moving the metal detector when searching for objects

• For best results, follow the steps below to learn how to move the metal detector when searching for objects:
• Move the detection probe slowly in order to ensure that all small objects are detected.

e) Isolating the detected object

f) Using headphones
The control unit (22) features a loudspeaker and a 3.5 mm headphone socket (10). The audible signals are played
through the loudspeaker unless a headset is connected. The loudspeaker is automatically disabled when a headset
is connected.
When a headset is connected, move the VOLUME dial (13) anticlockwise as far as it will go before
switching on the metal detector to prevent the risk of hearing damage due to an excessive volume!
• Move the detection probe in wavy lines across the target area (see left-hand
diagram).
• Keep the detection probe (1) at a uniform height above the ground (approx. 3-5 cm).
Ideally, the detection probe (1) should always be parallel to the ground. Always
ensure that the search area overlaps (approx. 50 %).
• Never move the detection probe like a pendulum. This changes the distance
between the detection probe and the ground, which affects the detection
accuracy. Only move the detection probe (1) with pendulum movements when
searching in troughs or dips to ensure that the detection probe stays parallel
to the ground.
• Swinging or lifting the detection probe will result in incorrect detection results
(see left-hand diagram).
• Move the MODE dial (16) to "TR2".
• With a little practice, you can identify an object's exact location. If the detection coil
finds a hidden object, hold the detection probe (1) exactly above this position.
• Move the detection probe (1) forwards and backwards and from side to side
in increasingly small movements. Mark the route accordingly. Note where the
detector beeps and narrow down the search area systematically with increasingly
small movements. Repeat this procedure at a right angle to the initial direction of
movement. The intersection of both imaginary lines is the point with the strongest
signal. This indicates the location of the detected object.
39