Renkforce D-R9005 Bedienungsanleitung Seite 4

Setting the time
• Press the MODE button (7) until the clock display appears on the LC display (1).
• Press and hold the MODE button (7) until the hour display of the clock flashes.
• Use the SET (6) button to set the hours.
• Press the MODE button (7) again. The minutes display of the clock flashes.
• Use the SET (6) button to set the minutes.
• Press the MODE button (7) again to save the setting.
• Press the SET button (6) while the time is displayed to switch between the time
display in 12h format and the display in 24h format.
Alarm time setting
• Press the MODE button (7) until the alarm time display appears on the LC display (1).
• Press and hold the MODE button (7) until the hour display of the alarm time flashes.
• Use the SET (6) button to set the hours.
• Press the MODE button (7) again. The minutes display of the alarm time flashes.
• Use the SET (6) button to set the minutes.
• Press the MODE button (7) again to save the setting. The alarm function is activated
automatically. You can tell thanks to a bell symbol in the display (1).
Activate/deactivate the alarm function
• Press the MODE button (7) until the alarm time display appears on the LC display (1).
• Press the SET button (6) in order to activate or deactivate the alarm function.
• When the alarm function is active, a bell symbol appears in the display (1); when the
alarm function is not active, the symbol does not appear.
• To switch off the alarm tone while it is going off, press one of the buttons SET (6),
MODE (7) or °C/°F (8). The alarm tone is switched off in this way, but the alarm func-
tion remains activated. The alarm sounds again on the following day.
If the alarm tone is not switched off manually, it breaks off automatically
after about 1 minute.
Thermometer function
• The room temperature appears in the lower lines of the display (1).
• To switch the unit of the display, press the °C/°F button (8).
Radio mode
• Set the desired reception range with the the SOURCE rotary switch (2).
AM = medium wave / FM = VHF
• Switch on the radio function by turning the VOLUME dial (4) clockwise.
Using this control, you can set the volume at the same time. The further you turn the
dial clockwise, the louder the playback is.
• Set the desired station with the TUNING dial (3) by turning it to the desired reception
frequency. The upper scale refers to the VHF reception, the lower to the medium-
wave reception.
• To switch the device off again, turn the VOLUME dial counter-clockwise to the OFF
position, where it clicks into place.
The receiver antenna is built into the housing. To optimise the reception, it
might be necessary to align the device differently or to place it in a spot with
better reception.
Operation with an external audio source
You can, if desired, connect an external audio source such as an MP3 player or a mo-
bile phone with audio playback to the device. The sound of the external source device
is then played back through the built-in speaker.
I f an external device is connected, the water resistance is no longer as-
sumed. Therefore, in this case, use the device only in dry conditions.
• Open the cover on the AUX/LINE IN connection (5).
• Plug the audio or headphone output of the external device into the AUX/LINE IN
connection (5). You can use the provided audio cord for this purpose.
• Turn the SOURCE rotary switch (2) to the AUX position.
• Begin the playback of the external device.
• Turn the VOLUME dial (4) clockwise to switch the device on and adjust the volume
as desired.
• To switch the device off again, turn the VOLUME dial counter-clockwise to the OFF
position, where it clicks into place.
• Unplug the external device again and close the AUX/LINE IN connection (5) with the
corresponding cover to restore the water resistance.
Use of the carrying handle
• Turn the carrying handle (9) downward to stand the device up.
• Turn the carrying handle (9) upward to carry the device or to hang it up by the han-
dle.
Maintenance and Care
Except for replacing the batteries, the device does not have to be serviced and, except
for occasional cleaning with a soft, dry cloth, requires no care whatsoever.
After use in the shower, the device should be carefully cleaned with a damp rag so
that soap residue cannot dry on it. However, in so doing, do not spray the device with
a strong water jet.
Never use aggressive cleaning agents or chemical solutions as these may damage
the surface of the case.
Disposal
Electronic devices are recyclable waste materials and must not be disposed
of in the household waste!
Dispose of an unserviceable product in accordance with the relevant statu-
tory regulations.
Remove the batteries if there are batteries inserted and dispose of them
separately from the product.
Disposal of used batteries/rechargeable batteries
As the end user, you are required by law (Battery Ordinance) to return all used bat-
teries/rechargeable batteries; disposal of them in the household waste is prohibited.
Batteries/rechargeable batteries containing harmful substances are marked
with the following symbols, which indicate that disposal in the household
waste is prohibited. The symbols of the relevant heavy metals are: Cd =
Cadmium, Hg = Mercury, Pb = Lead. You can return your used batteries/re-
chargeable batteries free of charge to the official collection points in your
municipality, in our stores, or anywhere where batteries or rechargeable
batteries are sold.
You thereby fulfil your statutory obligations and contribute to the protection of the
environment.
Technical Data
Batteries .............................................. 2 x 1.5 V Mignon cell (AA) for the radio operation
Battery life (clock).............................. approx. 2 years
Reception range ................................. MW 540-1710 kHz
Output performance .......................... 250 mW
Time display ........................................ 12/24h format
Temperature units .............................. °C/°F
Dimensions (W x H x D)..................... 120 x 130 x 72 mm
Weight .................................................. 240 g
Operating temperature range .......... 0-45 °C
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in technology and equipment reserved.
© Copyright 2014 by Conrad Electronic SE.
2 x 1.5 V coin cell AG13 (clock)
VHF 88.0-108.0 MHz