Connections - Denon DN-X500 Bedienungsanleitung

ENGLISH

CONNECTIONS

4
Refer to the Connection Diagram below.
1. Make certain AC power is off while making connections.
2. Quality cables make a big difference in fidelity and punch.
Use high-quality, audio cables.
3. Do not use excessively long cables. Be sure plugs and jacks
are securely fastened. Loose connections cause hum,
noise, or intermittence that could damage your speakers.
DN-X500
Main balanced power amplifier
Booth / power amplifier
ON
OFF
4. Connect all stereo input sources. Then connect any effects
into the stereo Effect, if used. Connect your Microphone(s)
and monitor headphones. Make sure all faders are at
"zero" and the unit is off. Take care to connect only one
cable at a time. pay attention to L and R position of jacks,
on both the DN-X500/DN-X900 and outboard gear.
5. Connect the stereo outputs to the power amplifier(s) and/or
tape deck(s) and/or MD recorder(s) and/or CD recorder(s).
Plug the DN-X500/DN-X900 into AC power outlet.
Main unbalanced power amplifier
GND
Cold
Hot
MADE IN CHINA
FABRIQUE EN CHINA MASTER OUT
BALANCED
BOOTH
R L
POWER
R L
FREQ.
40Hz 200Hz
SUB WOOFER/LIGHTING
Hot
Cold
1/4" Jack
GND
1/4" Mono Jack
Subwoofer with
Built-in amplifier
Lighting system
NOTE:
Always switch on your audio input sources such as CD players
first, then your mixer, and finally any amplifiers. When turning
off, always reverse this operation by turning off amplifiers,
then your mixer, and then input units.
Tape deck
CD player
TRACK M S F TRACK M S F
OPEN/ CLOSE T. REMAIN ELAPSED SINGLE CONTINUE PITCH CLOSE OPEN/ T. REMAIN ELAPSED SINGLE CONTINUE
1 2
PITCH
SEARCH SCAN SEARCH SCAN
PITCH BEND
PITCH% PITCH%
0%
JOG CONT./ JOG CONT./
MODE SINGLE TIME CUE PLAY/PAUSE MODE SINGLE TIME CUE
TRACK CUE TRACK CUE
REMOTE CONTROL UNIT RC-47
OPEN/CLOSE OPEN/CLOSE
1 1 2 2
POWER
ON OFF
R L L R R L L
UNBALANCED REC OUT LINE 8 LINE 7 LINE 6 LINE 5
L L L
ATT.
-10dB MONO
OFF ON OFF ON
R R R
R SEND L(MONO) R RETURN L(MONO) LINE 8 LINE 6
FADER FADER X-CONTROL
EFFECT
L R L R
Effects processor
OPEN/ OPEN/
CLOSE CLOSE
1 MEMO BRAKE PITCH KEY 2 MEMO BRAKE PITCH KEY
CONT./SINGLE TIME CONT./SINGLE TIME
END MON.
PROGRAM PITCH BEND PROGRAM PITCH BEND
NEXT TR. START END MON. LOOP A B NEXT TR. START END MON. LOOP A B
SEARCH 1 2 EXIT/ RELOOP PUSH ENTER SEARCH 1 2 RELOOP EXIT/ PUSH ENTER
SEARCH SCAN SEARCH SCAN
EFFECT FIL RVB FLG EFFECT FIL RVB FLG
REVERSE LOOP PITCH REVERSE LOOP PITCH
TAP ON/OFF DATA MASTER 0% TAP ON/OFF DATA MASTER 0%
STOP PLAY/WRITE STOP PLAY/WRITE
MODE MODE
CUE PLAY/PAUSE CUE PLAY/PAUSE
CUE CUE
PRESET PRESET
REMOTE CONTROL UNIT RC-46
OPEN/CLOSE OPEN/CLOSE
1 2
1 2
POWER
ON OFF
or Lighting
CD player
3
ENGLISH
Balanced or unbalanced
Microphones
Turntable 2 Turntable 1
PITCH
PITCH
PITCH BEND
0%
PLAY/PAUSE
KEY ADJUST PITCH KEY ADJUST PITCH
-12 -12
BRAKE SLOW BRAKE SLOW
Quartz 0 Quartz 0
OFF ON OFF ON
POWER POWER
+12 +12
/STOP START 78 /STOP START 78
33 45 DP-DJ151 Digital 33 45 DP-DJ151 Digital
R L R L R
MAIN MIC
PHONO2/ PHONO1/
LINE 4 LINE 3 LINE 2 LINE 1
L SIGNAL L SIGNAL
GND GND
PH LN PH LN
R R
LINE 4 LINE 2 TALK OVER
- -20dB
FADER FADER
AUX MIC
L R L R
OPEN/ OPEN/
CLOSE CLOSE
1 MEMO BRAKE PITCH KEY 2 MEMO BRAKE PITCH KEY
CONT./SINGLE TIME CONT./SINGLE TIME
END MON.
PROGRAM PITCH BEND PROGRAM PITCH BEND
NEXT TR. START END MON. LOOP A B NEXT TR. START END MON. LOOP A B
SEARCH 1 2 RELOOP EXIT/ PUSH ENTER SEARCH 1 2 RELOOP EXIT/ PUSH ENTER
SEARCH SCAN SEARCH SCAN
EFFECT FIL RVB FLG EFFECT FIL RVB FLG
REVERSE LOOP PITCH REVERSE LOOP PITCH
TAP ON/OFF DATA MASTER 0% TAP ON/OFF DATA MASTER 0%
STOP PLAY/WRITE STOP PLAY/WRITE
MODE MODE
CUE PLAY/PAUSE CUE PLAY/PAUSE
CUE CUE
PRESET PRESET
REMOTE CONTROL UNIT RC-46
OPEN/CLOSE OPEN/CLOSE
1 2
1 2
POWER
ON OFF
CD player
or 1/4" Jack
Microphones
1/4" Jack