C) Base Station: Free Standing Or Wall Installation - Conrad KW-9015 Bedienungsanleitung

• The base station may acknowledge the first receipt with a short tone signal.
• Make sure that the sealing rubber is correctly positioned in its guide slot. Occasionally it can
happen that it is pulled out by opening the battery compartment lid.
• Replace the battery compartment lid and screw it back on. Do not use force.
c) Reception unit: Free standing or wall installation
The reception unit can be set up free standing via the base stand (J) included in delivery on
an even, robust and sufficiently large surface.

The base station may be delivered with the base stand already inserted. If not,
the base stand is simply inserted from the bottom into the reception unit. Please
observe the correct position.
The reception unit can be suspended from a nail or screw on a vertical wall. There is a
corresponding opening on the back (F).
To remove the base stand (J) it is to be slid off towards the bottom.

Doing this, don't excert any force, don't bend the base stand, but simply pull it
out directly towards the bottom.
Before you knock a nail into the wall or fasten a screw into it (and drill a
hole for the dowel), make sure that there are no cables, power, gas or
water lines.
Attention! Lethal danger!
44