Package Contents; Safety Instructions; Operation - Renkforce 1267660 Bedienungsanleitung

G Operating instructions
Digital thermometer superslim
Item no. 1267660
Intended use
The product is used to measure and display the indoor temperature and humidity. Fur-
thermore, a digital clock and an alarm function with snooze function are integrated.
The product is operated using a battery of type AA/Mignon.
Always observe the safety instructions and all other information included in these op-
erating instructions.
Any use other than as described above is not permitted and can damage the product.
In addition, it can lead to hazards such as short-circuit, fire, etc.
This product complies with the applicable national and European requirements. All
names of companies and products are the trademarks of the respective owners. All
rights reserved.
Package contents
• Digital thermometer
• Operating instructions
Explanation of symbols
This symbol indicates specific risks associated with handling, function or
use.
The "arrow" symbol indicates special tips and operating information.
Safety instructions
D amage due to failure to follow these operating instructions will void the
warranty! We do not assume any liability for any resulting damage!
W e do not assume any liability for material and personal damage caused
by improper use or non-compliance with the safety instructions. In such
cases, the warranty will be null and void.
• The unauthorised conversion and/or modification of the product is not
permitted for safety and approval reasons (CE). Never open/dismantle it
(except as described in these operating instructions for inserting/replac-
ing the batteries).
• The manufacturer is not responsible for incorrect displays or measured
values and any consequences which may arise thereof.
• The product is intended for private use and not suited for medical pur-
poses or informing the public.
• The product is not a toy and does not belong in the hands of children. The
product contains small parts, glass (display) and a battery. Position the
product so it is out of the reach of children.
• The product is only suitable for dry, enclosed indoor areas. Do not expose
it to direct sunlight, strong heat, cold, dampness or wetness; otherwise it
may be damaged.
• When the product is taken from a cold room to a warm room (e.g. dur-
ing transport), condensation may be produced. This could damage the
product. Therefore, wait until the product has reached room temperature
before using it. This may take several hours.
• Do not leave packaging material carelessly lying around, since it could
become a dangerous plaything for children.
• Handle the product with care, it can be damaged by impacts, blows, or
accidental falls, even from a low height.
• If you have any questions that are not answered in these operating in-
structions, please contact our technical department or another specialist.
Notes on batteries and rechargeable batteries
• Batteries/rechargeable batteries must be kept out of the reach of children.
• Do not let batteries/rechargeable batteries lie around openly. There is a risk of bat-
teries being swallowed by children or pets. If they are swallowed, consult a doctor
immediately.
• Replace a flat battery/rechargeable battery in good time since flat or old batteries/
rechargeable batteries can leak.
• Leaking or damaged batteries/rechargeable batteries may cause acid burns when
coming into contact with skin, therefore use suitable protective gloves.
• Liquids leaking from batteries/rechargeable batteries are very chemically aggres-
sive. Objects or surfaces coming into contact with these liquids might be consider-
ably damaged. Thus, store batteries/rechargeable batteries in a suitable location.
• Normal/rechargeable batteries must not be short-circuited, opened or thrown into a
fire. There is a risk of explosion!
• Do not recharge normal, non-rechargeable batteries; there is a risk of explosion!
• Check that the polarity is correct when inserting the battery/rechargeable battery
(pay attention to plus/+ and minus/-).
It is possible to operate the product with a rechargeable battery. However,
the operating time and the display contrast are greatly reduced due to the
lower voltage (battery = 1.5 V, rechargeable battery = 1.2 V).
We therefore recommend to use high-quality alkaline batteries only instead
of rechargeable batteries to operate the product.
Controls
1 "UP" button
2 "MODE" button
3 "SNOOZE • LIGHT" button
4 "MEM" button
5 "RESET" button
6 "CF" button
7 Battery compartment cover
Getting started
• Open the battery compartment by folding its cover downwards.
• Insert a battery of type AA/Mignon with correct polarity into the battery compart-
ment (observe positive/+ and negative/-). All display segments appear briefly on the
display; then the first measured value for temperature and air humidity will be dis-
played.
• Close the battery compartment again.
• Place the product on a stable and level surface. Protect valuable furniture surfaces
by using a suitable mat to prevent scratches.
For operation, choose a place that is not directly exposed to the sun and not
located close to a radiator. This will lead to a false temperature or air humid-
ity indication.

Operation

a) Setting the time, 12h/24h mode and date/month
• To start the setting mode, the device must be in time mode (the colon between hours
and minutes blinks).
Keep the "MODE" button (2) impressed for about 2 seconds until minutes of the time
blink.
• Use the "UP" button (1) to set the minutes.
For quick adjustment, hold the "UP" button (1) down for a longer period of time.
If you do not press any button for one minute, the settings made up to this
point are saved and the settings mode is closed.
This also applies for the settings described below.
• Press the "MODE" button (2) and the hours will start to blink; set them using the
"UP" button (1).
• Briefly press the "MODE" button (2) and the "12h" or "24h" display for the 12h/24h
display mode will start to blink; set the desired mode using the "UP" button (1).
In the 12h mode, "AM" is displayed for before noon and "PM" for after noon.
• Press the "MODE" button (2) briefly and the month will start to blink; set it using the
"UP" button (1).
• Press the "MODE" button (2) briefly and the date will start to blink; set it using the
"UP" button (1).
• Briefly press the "MODE" button (2) to exit the setting mode.