Christopeit Sport AX 7 Montage- Und Bedienungsanleitung Seite 21

Assembly Instructions
Remove all the separate parts from the packaging, lay them
on the floor and check that all are there on the basis of the
assembling steps. Please note that a number of parts have
been connected directly to the main frame and preassembled.
In addition, there are several other individual parts that have
been attached to separate units. This will make it easier and
quicker for you to assemble the equipment. Assembly time
approx. 50min.
Step 1:
Attach the stabilizer (67+79) at main frame (52).
1. Attach the front foot (79) with the preassembled transport rollers
(78) to the main frame (52). Do this with the two screws (68),
curved washers (11), spring washers (15) and cap nuts (65).
Attention: Mount the front foot into right direction, so that the
transport rollers don't touch the floor during exercising.
2. Attach the rear foot (67) to the main frame (52). Do this with the
two screws (68), washers (11), spring washers (15) and cap nuts
(65). After assembly has been complete, you can compensate
for minor irregularities in the floor by turning the cap (66). The
equipment should be set up that the equipment does not move
of its own accord during a training session.
Step 2:
Assembling of the connection cable (81) to the motor cable (80)
and installation of support (82) at the main frame (52).
1. Place screws (12), curved washers (11) and spring washers
(15) accessibly beside the front part of the main frame (52) after
removing it from the base frame (52).
2. Place the lower end of the support (82) against the main frame
(52). Plug the ends of the two computer cable harnesses (80+81)
projecting from (52+82) together.
(Note: The computer cable harness (81) projecting from the
support (82) must not slide into the tube, as it is required for
later steps of installation.)
When joining the tubes, ensure that the cable connection will
not trapped.
3. Put one spring washer (15) and one curved washer (11) on each
screw (12). Push the screws (12) through the holes in the support
(82), screw into the threaded holes of the main frame (52) and
tighten lightly. (This screw connection point will screw firmly at
least in Step 4.)
21