Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Controls
a 4x charge connector
b Round socket for power supply
c Power LED
Getting started
a) Wall plug transformer
• First, put the power adapter applicable in your country on the wall
plug transformer, so that it snaps in securely.
• To remove the power adapter, keep the surface designated with
"PUSH" pressed with finger, while pulling adapter upwards.
Then you can put on another power adapter pressing it until it sits
firmly.
Never put the power adapter into a socket without the wall plug transformer connec-
ted thereto.
b) USB charger
• Connect the round socket (b) of the USB charger to the corresponding round plug on the
enclosed wall plug transformer. Plug the wall plug transformer into a standard mains socket.
The power LED (c) lights up.
• Place the USB charger on a level, flat, stable surface. Protect valuable furniture surfaces by
using a suitable mat to prevent scratches, pressure points or discolourations.
The USB charger and the wall plug transformer heat up during operation (depending
on the output current). Make sure that there is sufficient ventilation; never cover the
USB charger and the wall plug transformer during operation.
• The USB charger is now ready for operation; the four charging outputs can be used to con-
nect suitable equipment.
• After the connected devices have been charged, disconnect them from the USB charger.
Disconnect the wall plug transformer from the mains socket.
Keep the product in a dry, cool and dust free place and out of the reach of children.
Please note:
The USB charger is only intended for charging appropriate equipment (e.g. smart-
phones, tablets, etc.). It cannot be used as a USB hub and does not transfer any
data.
Maintenance and cleaning
The product does not require any maintenance and should never be disassembled for any
reason.
Disconnect the product from the mains voltage before cleaning.
Only clean the product with a soft, clean, dry cloth. Dust can easily be removed using a clean,
soft brush and a vacuum cleaner.
Never use aggressive cleaning agents or any chemicals at all for cleaning; these can lead not
only to discolouration, but can also damage the product.
Disposal
Electronic devices are recyclable material and do not belong in the household waste.
Please dispose of the device, when it is no longer of use, according to current statu-
tory requirements.
Technical data
a) General
Ambient conditions ............................... Temperature 0 °C to +55 °C, air humidity 10% to 90%
b) USB charger
Operating voltage .................................5 V/DC
Charging outputs ..................................4 (USB ports of type A)
Output voltage ......................................5 V/DC
Output current per charging output .......max. 2.4 A
Output current (combined) ....................max. 3.5 A
Output power (combined) .....................max. 17.5 W
Dimensions ...........................................40 x 80 x 18 mm (L x W x H)
Weight ..................................................55 g
c) Wall plug transformer
Operating voltage .................................100 - 240 V/AC, 50 Hz
Output ...................................................5 V/DC, 3.5 A
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
(www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming,
or the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited. This publication represent the technical status at the time of
printing.
© Copyright 2015 by Conrad Electronic SE.
relative, not condensing
Werbung
Inhaltsverzeichnis
