VOLTCRAFT Quadro B6 Bedienungsanleitung Seite 72

• If the value for the discharging current must be changed, push the „START/ENTER" button. The discharging
current flashes. Change the discharging current using the buttons „INC" and „DEC". Keep the respective button
pressed for quick adjustment.
Confirm the set discharging current with the „START/ENTER" button.
The maximum possible discharging current depends on the battery type and number of cells. The max.
discharging output per channel is 10 W.
• To begin the discharge process, keep the „START/ENTER" button pressed for longer (approx. 3 seconds).
If the settings are wrong, or if the charger detects a problem, an audio signal is emitted and the appropriate
information is shown on the display. You can stop the warning signal by pressing the „BATT.TYPE/STOP"
button. The charger then returns to the previous configuration menu.
The display shows, e.g., the following data while discharging:
The rechargeable battery type is shown in the upper left („Pb" = lead batte-
ry), the upper middle shows the discharging current and the upper right the
current rechargeable battery voltage.
The lower left shows the current rechargeable battery programme („DSC" = „DISCHARGE"), the middle the
elapsed discharging time and the discharged capacity is mAh is displayed to the right of this.
• Once the discharging process has been completed, an audio signal is emitted (if it was not turned off).
If you wish to cancel the discharging process, push the „BATT.TYPE/STOP" button.
72
Pb-6 0.4A 12.59V
DSC 022:45 00132