Herunterladen Inhalt Inhalt Diese Seite drucken

3M Peltor WS SportTac Bedienungsanleitung Seite 9

Vorschau ausblenden Andere Handbücher für Peltor WS SportTac:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 35
3:9 Changing settings in the Configure menu
The headset has a Configure menu where you can adjust settings.
To access the menu, press and hold the (–) and (+) buttons for 2 seconds (with
the headset switched on).
Access to the Configure menu is confirmed by a voice saying:
To change the settings, use the (–) and (+) buttons. To move on through the
Configure menu, press briefly on the On/Off/Mode button (A:13).
See quick guide for information on how the menu is set up and where the
functions are located.
Bass Boost
Bass Boost gives a fuller bass sound to streamed stereo music.
Music Limiter Mode
There are two settings for limiting the sound level when streaming music/audio
with Bluetooth
• ON
The limiter will reduce the volume level to 82 dB(A) Leq over 8 hours
• OFF limits the total sound exposure over 8 hours to 82 dB(A) Leq
If the volume is set above 82 dB (A) it will be reduced to a very low volume,
once the daily dose is reached.
This is confirmed by a voice saying:
The dosimeter will reset every 24 hours.
Warning: Daily dose coul be exceeded if batteries are removed and replaced,
or if factory default is activated.
Balance
Changes the left-right balance of the surround sound.
Equalizer
Changes the frequency character of the surround sound.
• Low
• Normal
• High
• Extra High
External Input (only applies to audio input J22 – A:12)
• OFF – use this mode when the J22 audio input is not in use
• ON – use this mode if a cord is plugged into the J22 audio input
• Microphone – use this mode if a boom microphone is plugged into the J22
audio input
Side tone volume (applies only to Hands Free Bluetooth sound)
• OFF
• LOW
• NORMAL
• HIGH
Side tone nuise reduction
• ON
• OFF
Reset to Factory Default
Resets all functions to the factory settings.
3:10 Connecting external equipment via a cord
External equipment can be connected via the J22 audio input (A:12) or
the 3.5 mm jack (A:11). For information on various cords, see Spare Parts/
Accessories (I).
"daily dose reached".
5
"menu".

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Peltor ws5Peltor ws workstyle

Inhaltsverzeichnis