Buffalo HD-WLU3R1 Benutzerhandbuch Seite 32

One or both of
the access LEDs is
blinking red
Both access LEDs
are glowing red
An access LED is
completely off
The corresponding access LED blinks green when a drive is being accessed. During RAID maintenance,
the power LED glows purple.
A rebuild is in progress. Normally this happens after a
hard drive is replaced in RAID 1 mode. Do not turn off the
power until rebuilding is complete. When rebuilding is
complete, the unit will beep three times and the access
LED will glow a steady green (not blinking). During
the rebuild, turning off the power can damage the unit or
(Short beeps) corrupt data.
During the rebuild, you may be able to continue to use the
DriveStation normally, but data transfers will be slower.
In RAID 1 mode with no computer connected, the rebuilding
process takes about 45 minutes per 100 GB. The DriveStation
will take about 7 hours and 20 minutes to rebuild. These
times are estimated.
Beep for about
The DriveStation is not recognized. Check the USB cable
three seconds and
connecting the DriveStation to your computer.
stops
The hard drive is not connected correctly. Make sure that
－
the drives are firmly seated inside the DriveStation.
HD-WLU3 User Manual
31