Raid.maintenance.(Windows.only) - Buffalo HD-WLU3R1 Benutzerhandbuch

RAID Maintenance (Windows Only)
In the RAID Utility, the RAID Maintenance function can be set for periodically checking for errors due to
bad sectors and automatically rebuilding when an error is found. The RAID Maintenance function is set
as shown below.
Note: The screens may vary depending on the OS you are using.
1
Right-click the
2
Click the [Monitoring config] tab.
3
Notes: ・ During RAID maintenance, the power LED glows purple and the access LEDs blink
green. You may continue to use the DriveStation during RAID maintenance, but this
increases the time required for RAID maintenance to complete.
・ To see the time remaining, hover the mouse cursor over the RAID maintenance icon.
However, if the time remaining is more than 24 hours, it will not be displayed.
RAID maintenance is now configured.
26
HD-WLU3 User Manual
in the taskbar, and select [Option].
① Specify the interval that the RAID
② Click [Config].
maintenance function is executed.
C l i c k i n g [ E xe c u t e m a i n t e n a n ce ]
i m m e d i a t e l y e xe c u t e s t h e R A I D
Maintenance.
Go to Next Page