Building A Raid Array - Buffalo HD-WLU3R1 Benutzerhandbuch

Building a RAID Array

Use the procedure below to build a RAID array.
Be sure to read "Notes on Building a RAID Array" on page 12.
Caution
Note: The example below shows Windows 7. Your screens may look slightly different.
1
Start the RAID Utility.
In Windows, right-click the
In the Macintosh, double-click
2
Click [Config], and click [Disk Config].
What should I do when the screen below appears?
The screen below is displayed when there is a preset password. Enter the password, then click
[OK].
Caution If you have forgotten the password, the RAID array cannot be built. Please contact
the Buffalo Support Center.
icon in the taskbar, and select [Open Utility].
(RaidUtility) that was copied to the Desktop.
Click [Config], and select [Disk Config].
① Enter the password (20 alphanumeric
characters or less).
② Click [OK].
Go to Next Page
HD-WLU3 User Manual
17