Abus TVIP52500 Bedienungsanleitung Seite 304

Syntax:
http://<servername>/cgi-bin/admin/ipfilter.cgi?
method=<value>&[start=<ipaddress>&end=<ipaddress>][&index=<value>]
[&return=<return page>]
PARAMETER VALUE
Method addallow
adddeny
deleteallow
deletedeny
start <ip address>
end <ip address>
index <value>
return <return page>
UART HTTP tunnel channel
Note: This request requires operator privilege
Method: GET and POST
DESCRIPTION
Add a set of allow IP address range to server. Start and end
parameters must be specified. If the index parameter is
specified, it will try to add starting from index position.
Add a set of deny IP address range to server. Start and end
parameters must be specified. If the index parameter is
specified, it will try to add starting from index position.
Remove a set of allow IP address range from server. If start and end
parameters are specified, it will try to remove the matched IP address.
If index is specified, it will try to remove the address from given index
position. [start, end] parameters
have higher priority then the [index] parameter.
Remove a set of deny IP address range from server. If start and end
parameters are specified, it will try to remove the matched IP address.
If index is specified, it will try to remove the address from given index
position. [start, end] parameters
have higher priority then the [index] parameter.
The start IP address to add or to delete.
The end IP address to add or to delete.
The start position to add or to delete.
Redirect to the page <return page> after the parameter is assigned.
The <return page> can be a full URL path or relative path according to
the current path. If you omit this parameter,
it will redirect to an empty page.
(capability.nuart>0)
304