Fuse Replacement; Cleaning - MC Crypt 59 13 95 Bedienungsanleitung

Maintenance
Always observe the following safety instructions before cleaning or servicing the effect beamer:
Wait for 10 minutes before opening the device after switching it off!
Live components may be exposed if covers are opened or components are removed.
The device must be disconnected from all power sources before any servicing or repair
work is carried out.
Capacitors inside the device may still carry voltage even though they have been
disconnected from all power sources.
Only qualified experts familiar with the hazards involved and the relevant regulations
must perform repairs.

Fuse Replacement

If the fuse must be replaced, observe that only fuses of the indicated type and rated current (see Technical Data)
must be used.
Never repair fuses or bridge the fuse holder.
• Unplug the mains plug from the mains socket and disconnect the low-voltage cable from the POWER mains
socket on the device.
• Use a suitable screwdriver to carefully push out the fuse holder with the defective fuse at the POWER mains
connection.
• Remove the defective fuse and replace it with a new fuse of the indicated type.
• Carefully push the fuse holder with the new fuse back into its position at the mains connection of the device.
• After this, you can reconnect the device to the mains and take it into operation.

Cleaning

The outside of the effect light should only be cleaned with a soft, dry cloth or brush. The glass lenses may
be cleaned with a commercially available glass cleaning agent.
Never use any aggressive cleaning agents or chemical solutions for the casing. They may damage the surface
of the casing.
28