Important User Information - Clearaudio SMART MATRIX Bedienungsanleitung

4. Important operation instructions
⇒ Never take out the vacuum arm tube while the machine is switched on !
⇒ Please make sure there is enough Ventilation in the room while you are using the
Smart Matrix !
⇒ Never use cleaning fluid which is foaming or intended !
⇒ Never (under any circumstances) use recycled fluid. Damage to the machine or
records may occur !
⇒ For the cleaning of your records, use only approved cleaning fluids for record cleaning
machines. Never use any aggressive, heavy alcoholic based fluids or acids with your
Smart Matrix !
⇒ Due to the highly efficient vacuum suction of the machine, during a constant use,
higher niose levels can be achieved. Please protect your ears with appropriate materials
when using the machine over longer periods.
⇒ Please wipe off any extra fluids, which appear on the machine surface immediately,
with for e.g. an appropriate towel !
⇒ Empty the vacuumed fluid always after 15 – 20 cleaned records !
Smart Matrix
⇒ Your
will shut off the machine automatically when the tank is full. This will happen when
there is aprox. 350 ml fluid in the tank. Please empty the tank as described on page 9 (
point 7 ). Please make sure that you have switched off the vacuum button, so the
machine will not vacuum automatically while you empty the tank. Damage to the
machine could occur.
⇒ The vacuum engine of your
internal temperature of the machine becomes too hot, the machine will shut off
automatically. In this case, please switch the machine completely off and wait at least
30 minutes, before you start using the
Seite 23
has a build in sensor in the fluid tank. To prevent any damage, this
Smart Matrix
Smart Matrix
Smart Matrix
has a build in temperature sensor. If the
again !
© clearaudio electronic GmbH 2006
l
Bedienungsanleitung / USER MANUAL
your