Mains - Philips CDR795 Benutzerhandbuch

Direct digital optical connection
This connection is required for direct recording from any
digital audio equipment with a digital optical output
(e.g. CD player or DVD player).
DIGITAL OUTPUT
OPTICAL
OPTICAL
IN
1
Remove the dust caps from the digital optical input of the
CD player/recorder and from the digital optical output of
the external appliance. Keep the caps in a safe place.
2
Use a digital optical cable to connect the optical output of
the external appliance with OPTICAL IN on the
CD player/recorder. Make sure you insert both plugs fully,
until a click is heard.
Recording can be done now via the digital optical input.
0 0
Press INPUT repeatedly on the CD player/recorder to
select the digital optical input.
OPTICAL IN is displayed.
Digital coaxial connections via a digital receiver
If you have a receiver with digital coaxial in- and outputs,
these connections allow you to make digital recordings
from various sources, connected to the receiver.
OPTICAL AUX
IN
OUT
DIGITAL
OPTICAL
IN OUT IN
Use a coaxial cable to connect the digital coaxial input of
the receiver with DIGITAL OUT on the
CD player/recorder. Use another coaxial cable to connect
the digital coaxial output of the receiver with DIGITAL IN
on the CD player/recorder.
Recording can be done now with any digital appliance,
0 0
connected to a digital input of the digital receiver
(e.g. CD player or DVD player). Press INPUT on the
CD player/recorder repeatedly to select the digital coaxial
input.
DIGITAL IN is displayed.
ANALOG OUTPUT
L
COAX
R
CD PLAYER
DIGITAL ANALOG
L
R
CD PLAYER/
OUT IN OUT IN OUT
RECORDER
CD IN DVD IN
DIGITAL
RECEIVER
ANALOG
L
R
CD PLAYER/
OUT IN OUT
RECORDER
Digital optical connections via a digital receiver
If you have a receiver with digital optical in- and outputs,
these connections allow you to make digital recordings
from various sources, connected to the receiver.
OPTICAL
OPTICAL
IN
1
Remove the dust caps from the digital optical in- and
outputs of the CD player/recorder and from the digital
optical output of the receiver. Keep the caps in a safe place.
2
Use a digital optical cable to connect the optical input of
the receiver with OPTICAL OUT on the
CD player/recorder. Use another digital optical cable to
connect the optical output of the receiver with
OPTICAL IN on the CD player/recorder. Make sure you
insert the plugs fully, until a click is heard.
Recording can be done now with any digital appliance,
0 0
connected to a digital input of the digital receiver
(e.g. CD player or DVD player). Press INPUT on the
CD player/recorder repeatedly to select the digital optical
input.
OPTICAL IN is displayed.

Mains

The type plate is located on the rear of the set.
1
Check whether the mains voltage as shown on the type
plate corresponds to your local mains voltage. If it does not,
consult your dealer or service organisation.
2
Make sure all connections have been made before
switching on the mains supply.
3
Connect the mains cable supplied to AC MAINS ~ and to
the wall socket.This switches on the mains supply.
When the set is switched to standby, it is still consuming
some power. To disconnect the set from the mains
completely, remove the mains plug from the wall
socket.
For users in the U.K.: please follow the instructions on
page 2.
Installations
AUX CD IN DVD IN
IN
OUT
DIGITAL
RECEIVER
DIGITAL ANALOG
L
R
CD PLAYER/
OUT IN OUT IN OUT
RECORDER
9