General Information; Technical Data; Environmental Information; Supplied Accessories - Philips CDR795 Benutzerhandbuch

Technical Data

Subject to modification without notice.
General
Power consumption
Active _______________________________ < 20 W
Standby ______________________________ < 0.6 W
Dimensions, w × h × d ____________ 435 × 88 × 310 mm
Weight ____________________________________ 5 kg
Audio
Frequency response ____________________ 2–20,000 Hz
Playback
S/N (A-weighted) _______________________ 120 dB
S/N __________________________________ 110 dB
Dynamic range __________________________ 98 dB
Total harmonic distortion _________________ -95 dB
Channel separation ______________________ 105 dB
Recording
S/N (A-weighted) ________________________ 93 dB
S/N digital without SRC ____________ equal to source
Dynamic range __________________________ 90 dB
Total harmonic distortion + noise ___________ -86 dB
Digital/optical input ___________________ 12–96 kHz
Laser (CD recorder)
Type ___________________ Semiconductor laser GaAIAs
Wave length ___________________ 775–795 nm (at 25°)
Output power ________ 2.5 mW (Read), 35 mW (Write)
Beam divergence ________________________ 60 degree
®
As an ENERGY STAR partner,
Philips has determined that this
product meets the ENERGY STAR
guidelines for energy efficiency.
This set complies with the radio interference
requirements of the European Community.
CAUTION
Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
CAUTION
INVISIBLE LASER RADIATION WHEN OPEN.
AVOID EXPOSURE TO BEAM.
Note:This warning is located inside
the enclosure.
®

General information

Environmental information

All redundant packing material has been omitted.We have
done our utmost to make the packaging easily separable
into three mono materials: cardboard (box), polystyrene
foam (buffer) and polyethylene (bags, protective foam
sheet).
Your set consists of materials which can be recycled if
disassembled by a specialised company. Please observe the
local regulations regarding the disposal of packing materials,
exhausted batteries and old equipment.

Supplied accessories

– 2 analogue audio cables (with red and white plugs)
– Remote control
– 2 batteries for the remote control, size AA
– Mains cable

Maintenance

Clean the set with a soft,
slightly dampened, lint-free cloth. Do
not use any cleaning agents as they
may have a corrosive effect.
Do not expose the set, batteries or
discs to humidity, rain, sand or
excessive heat (caused by heating
equipment or direct sunlight).

Disc handling

If the CD player/recorder fails to read discs correctly use a
commonly available cleaning CD to clean the lenses before
submitting the set to repair. Other cleaning methods may
destroy the lenses. Always keep the trays closed to avoid
dust on the lenses.
The lenses may cloud over when the set is suddenly moved
from cold to warm surroundings. Playing a disc is not
possible then. Leave the set in a warm environment until
the moisture evaporates.
To take a disc out of its box easily,
press the centre spindle while lifting
the CD(RW). Always pick up a
CD(RW) by the edge and put it
back in its box after use.
Never write on a CD or attach a
sticker to it.Write only on the printed side of a CDR or
CDRW, and only with a soft felt-tipped pen.
To clean a disc, wipe it in a straight
line from the centre towards the
edge using a soft, lint-free cloth. A
cleaning agent may damage the disc!
5