Installation; Boring The Wall; Mounting The Hood Body - Beko CWB 9831 ANP Bedienungsanleitung

3

Installation

3.1 Boring the wall

Type Hood 45
180
X
If you want to use the hood in suction version with
the air outlet at the back of the hood, make sure
to follow the indications given below in the draw-
ing for a correct boring operation of the air outlet
opening.
When installing the hood in recycling version it has
to be taken into consideration that space remaining
between the hood and the upper limit (ceiling or
self) is at least 8-10 cm.
On the wall, trace:
• a vertical line up to the ceiling or top limit, at the
centre of the area where you intend to fit the
hood;
• a horizontal line at: 650 mm min. above the
cooking hob;
• As shown, mark a reference point at 847 mm
above the horizontal reference line, and at X mm
(X= see table in figure) to the right of the vertical
reference line.
• Repeat this operation on the opposite side,
checking levelling.
• Drill the points marked using a ø 12 mm bit
• Insert plugs with screws and brackets 11a in the
holes then tighten them.
Hood / User Manual
60 90
240 390
Rear air outlet
zone
• As shown, mark a reference point at 53 mm
above the horizontal reference line, at the center
of the of the vertical reference line.
• Drill the points marked using a ø 8 mm bit.
• Insert the plug 11 in the hole.

3.2 Mounting the hood body

• Remove the metal grease filters by turning the
handles provided.
• Adjust the two screws Vr, on brackets 11a, to a
minimum.
• Hook the hood canopy onto the two brackets
11a.
• From inside the hood canopy, adjust the screws
Vr to set the Hood Canopy level.
• Tighten the safety screw 12a.
7 / 111 EN