MC Crypt GLPS6-RGY Bedienungsanleitung Seite 36

11. Operation
CH 1 = 225-255
CH 2
CH 3
zoom
CH 4
Y axis
rolling
CH 5
X axis
rolling
CH 6
Z axis
rotation
CH 7
X axis
movement
CH 8
Y axis
movement
CH 9
colour
e) Slave operation
In this operating mode, the controller of the connected master device controls the slave devices. That means that each slave
device synchronously reproduces the laser patterns of the master device.
Perform the connection as described earlier under "Setting up a master-slave chain".
• Press FUNC button repeatedly until SLA flashes in the display.
• Confirm your selection by pressing ENTER.
• The laser then operates in slave mode and is synchronously controlled by the controller of the connected master device.
36
000-255 32 grating effects
000-127 Zoom effect (100 % → 5 %)
128-169 Zoom-in effect
170-209 Zoom-out effect
210-255 Combined zoom-in/out effect
000-127 0 - 359º
128-191 Clockwise rolling
192-255 Anti-clockwise rolling
000-127 0 - 359º
128-191 Clockwise rolling
192-255 Anti-clockwise rolling
000-127 0 - 359º
128-191 Clockwise rotation
192-255 Anti-clockwise rotation
000-127 128 different fixed positions on X axis
128-191 Clockwise movement
192-255 Anti-clockwise movement
000-127 128 different fixed positions on Y axis
128-191 Clockwise movement
192-255 Anti-clockwise movement
000-015 Original colour
016-031 Colour 1
032-047 Colour 2
048-063 Colour 3
064-160 Single colour, alternating speeds
161-255 Mixed colours, alternating speeds