• The intercom can optionally be used as a mobile device or attached to a flat wall.
• For this purpose, mark the required holes according to the holder distance and drill two holes.
• Screw in both screws until the screw head protrudes approx. 3 mm from the wall. Hang the product from above.
• Open the intercom cover with a screwdriver and insert 3 identical AAA batteries. Pay attention to the printed correct
polarity.
9. Operation
The intercom must be paired with the doorbell. For this purpose, both products must be powered and within range
(maximum 120 m distance). If your mobile phone is not within range, you will still be notified if somebody rings the
doorbell. To pair the products with each other, press the "Ringtone selection" buttons one after the other, connect to
the intercom and press the bell button on the doorbell. The products are now paired.
Buttons:
To disconnect, press and hold down the connection on the intercom.
Press the eighth note button to select the desired ringtone from a wide range of ringtones.
Use the volume button to turn the ring volume up stepwise from quiet to loud and vice versa.
Use the bell and light selector switch to change the combination of ringtone and light signal for the respec-
tive bell operation.
25