Getting Started - VOLTCRAFT HygroCube 100 Bedienungsanleitung

10. GETTING STARTED

Connect mains adapter
The VOC sensor of the HygroCube 100 functions fully only with the wall plug transformer enclosed. Plug the
wall plug transformer's low-voltage plug into the socket (15) located on the side of the measuring device.
Connect the wall plug transformer to a socket connected to the national grid..
Initial calibration and warm-up phase
The warm-up phase for the VOC sensor lasts about 15 min. at an ambient temperature of 22 °C. H-UP is
indicated on the display during this time.
In the first 72 hours, the air quality sensor adapts automatically to all of the ambient conditions and thus, can
deliver out-of-spec values.
Discrepancies continuing to occur even after this period may be remedied by changing the position
of the HygroCube.
25