Technical Data - Renkforce 1013327 Bedienungsanleitung

• Always treat hard disks with care. Impacts during operation (also for a few seconds
after switching off) may cause the write/read head to touch the magnetic disk,
which destroys the hard disk.
• When connecting the hard drive for the first time, it may take up to one minute for it
to be recognised. The time may vary depending on operating system and hardware
used.
• A new hard disk has to be partitioned and formatted before it can be used and
displayed e.g in the Windows® file manager.
• With Windows® 7, navigate in the Control Panel to "System and Security". Click on
"Administrative Tools" and then on "Create and format hard disk partitions".
• There, select the correct hard drive and create a new partition. Afterwards, the hard
drive needs to be formatted.
• Hard disk drives for Macintosh computers use a different file system than Microsoft
Windows®. The native HFS+ file system for Macintosh is not compatible with
Windows® without conversion. If the hard disk drive is to be used for both operating
systems, format the hard disk drive with a file format that is compatible with both
operating systems (e.g., FAT32).
• Note that certain operating systems do not support external storage drives larger
than 2 TB, namely Windows® versions lower than XP 64 bit (including XP 32 bit).
For more information on the support for your operating system, please contact the
customer service of the operating system manufacturer.
• If you are not sure about the formatting procedure, contact a specialised computer
retailer.
Cleaning
• Disconnect the product from the computer and from the power supply (disconnect
the power supply unit) before cleaning it.
• Use a clean, dry soft cloth for cleaning. Do not use any aggressive cleaning agents
as these may result in discoloration of the housing.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the
household waste.
At the end of its service life, dispose of the product according to the
relevant statutory regulations.
You thus fulfil your statutory obligations and contribute to the protection of the
environment.

Technical data

Docking station
Suitable for ........................................... SATA, 2.5" (6.4 cm), HDD or SSD
USB standard.......................................USB 3.0 (max. 5 GBits/s) / USB 2.0
System requirements .........................Windows® 98SE (only USB 2.0),
Cable length .........................................90 cm (USB 3.0 cable)
Dimensions (W x H x D)......................153 x 86 x 91 mm
Weight ...................................................approx. 300 g
Current consumption ..........................max. 950 mA
Power adaptor
Input voltage/-current ........................100 – 240 V/AC, 50/60 Hz / max. 0.6 A
Output voltage/-current .....................12 V/DC / 2 A
Cable length .........................................153 cm
SATA, 3.5" (8.9 cm), HDD or SSD
(max. 480 MBits/s)
ME (only USB 2.0), 2000 (only USB 2.0), XP
(Home, Pro, with SP1, SP2, SP3, only 32 Bit),
Vista™ (32 Bit and 64 Bit), 7 (32 Bit and 64 Bit), 8,
8 Pro, Mac OS 9.0 and higher, Linux Ubuntu 2.4.18
and higher
These operating instructions are published by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in technology and equipment reserved.
© Copyright 2014 by Conrad Electronic SE. V1_0314_02-Ctse