Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Product safety
•
The measuring device may be used in installations of overvoltage category III in accordance with
IEC 664, provided the voltage in the measurement circuit does not exceed 250 V ACrms/DC.
•
Do not switch the measuring instrument on immediately after it has been taken from a cold to
a warm environment. Condensation moisture that forms could destroy your device. Leave the
device switched off and wait until it has reached room temperature.
Battery safety
•
Make sure that the polarity is correct when inserting the batteries.
•
Remove the batteries if you are not using the device for a longer period, so as to prevent damage
due to leakage. Leaking or damaged rechargeable batteries can cause acid burns upon contact
with the skin. You should therefore wear safety gloves when handling damaged rechargeable
batteries.
•
Keep batteries out of reach of children. Do not let batteries lie around openly, since they could be
swallowed by children or pets.
•
All batteries should be replaced at the same time. Mixing old and new batteries in the device can
lead to leaking of the batteries and to damage to the device.
•
Do not dismantle or short-circuit rechargeable batteries and do not throw them into an open fire.
Never try to charge non-rechargeable batteries. There is a danger of explosion!
Miscellaneous
•
Repairing of the device may only be carried out by an expert or specialised repair shop.
•
If you have queries about handling the measuring device that are not answered in these operating
instructions, our technical support is available under the following address and telephone number:
Voltcraft ®, 92242 Hirschau, Lindenweg 15, Germany, Tel.: +49 (0)180 / 586 582 7
23
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
