Dual Watch - Motorola Talkabout T82 Bedienungsanleitung

and Sub-Code settings from the Leader's radio. All Members'
radios will remain in this mode for 3 minutes.
• A group with many radios should have all users take this step at the
same time, so all radios can be programmed in one go.
3. On the Leader's radio, press and hold down the
until you hear a double beep.
Note:
• At the double beep, this radio's Channel and Sub-Code settings
will be transmitted, which will be received and copied by all the
other (Members') radios.
• The Leader's radio must make this transmission when all the
Members' radios are still in the Easy Pairing mode, otherwise the
transmission will not be picked up.
• On the Leader's radio, user must remember NOT to release the
button on the first (single) beep, otherwise this radio will become
another Member's radio. If that happens, you can press PTT to
escape, and retry the steps described in #3 again.
• If the Leader's radio is set to a channel between 9 and 16, please
ensure that all Members' radios have channels 9 to 16 activated.
• When a Member's radio with only 8 Channels is being Easy-
Paired by a Leader's radio on Channel 9 or above, Easy-Pairing
will fail, indicated by three short beeps, and "Err" is displayed
briefly.
Internal Voice Operated Transmission/
Voice Operated Transmission (
Transmission is initiated by speaking into the microphone of
the radio/audio accessory instead of pushing the PTT
button.
L3 = High Sensitivity for quiet environments
L2 = Medium Sensitivity for most environments
L1 = Low Sensitivity for noisy environments
1. Press Menu until the
display. When audio accessory is connected, the
button
/ )
icon appears on the
icon will be shown. The current setting (Off, L1–L3) will
flash.
2. Press or to select the sensitivity level.
3. Press the PTT button to exit menu or
set up.
Note: When using iVOX/VOX, there will be a short delay.

Dual Watch

Enables you to scan the current channel and another
channel alternately.
To set another channel and start Dual Watch:
1. Press Menu until the Dual Watch
The Dual Watch icon will flash.
2. Press or to select the channel then press
3. Press or to select the Sub-Code.
4. Press the PTT button or wait until time out to activate
Dual Watch. The screen will alternate between home
channel and Dual Watch channel.
5. To end Dual Watch, press
Note: If you set the same channel and Sub-Code as the current channel,
Dual Watch does not work.
Silent Mode (Vibrate Alert)
Silent Mode (Vibrate Alert) notifies you that your radio is
receiving a message. This is useful in noisy environments.
The Vibrate Alert will be triggered when you received a call.
It will then only be triggered again if there is no activity within
30 seconds after the previous call.
1. Press Menu until the Vibrate Alert
The current setting will flash.
Menu to continue
icon appears.
Menu.
Menu.
icon is displayed.
7