Herunterladen Diese Seite drucken

Werbung

Montage- und Bedienungsanleitung
Assembly and operating instructions
Notice de montage et d´utilisation
Amica
No. 3133

Werbung

loading

Inhaltszusammenfassung für ROBBE Amica

  • Seite 1 Montage- und Bedienungsanleitung Assembly and operating instructions Notice de montage et d´utilisation Amica No. 3133...
  • Seite 2 Total surface area loading: approx. 16.3 g/dm Power system Sequence of assembly The Amica can be fitted with a brushless (outrun- The model should be assembled as shown in the ner) motor for direct drive. individual drawings. The texts only refer to points which are of particular importance.
  • Seite 3 Recommandations concernant le collage : pour coller les pièces en polypropylène expansé, les pièces en bois et en plastique, utiliser la colle cyanoacrylate robbe Speed type 2 - “CA”. Pour les pièces en polypropylène expansé composites avec des éléments en Depron : utiliser la...
  • Seite 4 Bauanleitung, Assembly instructions, Notice de montage Amica 3133 290 mm...
  • Seite 5 Bauanleitung, Assembly instructions, Notice de montage Amica 3133 Schlitze auf beiden Seiten einschneiden Cut slots on both sides Entailler des fentes des deux côtés. Verstärkungsschnüre einziehen Draw the reinforcing cords through Enfiler les ficelles de renfort Verstärkungsschnur Rumpf Reinforcing cord...
  • Seite 6 Bauanleitung, Assembly instructions, Notice de montage 3133 Amica Verstärkungsschnüre spannen und verkleben. Tension the reinforcing cords and glue them. Tendre et coller les ficelles de renfort. Oberseite Extrados Unterseite Bottom Intrados 90° Unterseite Bottom Intrados...
  • Seite 7 Bauanleitung, Assembly instructions, Notice de montage Amica 3133 Gestänge anpassen, Nut einschneiden, Röhrchen am Rumpf verkleben Adjust the pushrod as required, cut a channel and glue the sleeve to the fuselage. Ajuster la timonerie, entailler une encoche, coller les tubes au fuselage...
  • Seite 8 Bauanleitung, Assembly instructions, Notice de montage Amica 3133 R E G iv e r re c e M ic ro (45 mm) “C.G.” 40 mm 50 mm 95-105 mm Die Servos mit der Fernsteuerung auf neutral stellen. Empfänger, Regler und Akku so mit Klettband platzieren, dass der Schwerpunkt “C.G.”...
  • Seite 9 Sicherheitshinweise 3133 Amica...
  • Seite 10 Safety Notes 3133 Amica...
  • Seite 11 Consignes de sécurité 3133 Amica...
  • Seite 12 GmbH & Co. KG Sous réserve de d’erreur et de modification technique. Copyright robbe-Modellsport 2006 Copie et reproduction, même d’extraits, interdites sans autorisation écrite expresse de la Société robbe-Modellsport GmbH & Co. KG robbe Modellsport GmbH & Co. KG Metzloserstr. 36 D-36355 Grebenhain...