Adjusting Speaker Volume; Receiving A Signal; Transmitting A Signal - Silvercrest TWINTALKER 4810 Gebrauchsanweisung

When the battery charge level is low, the battery icon will flash and a beep will be heard to
indicate that the batteries need to be replaced or recharged.
Never recharge non-rechargable batteries like for exemple Alkaline
batteries.

13.3 Adjusting Speaker Volume

13.4 Receiving a Signal

The unit is continuously in the receive mode when the unit is switched ON and not
transmitting.
In order for other people to receive your transmission, they must also be
on the same channel and have set the same CTCSS code or DCS code.
(See chapter "13.6 Changing Channels" and "13.7 CTCSS (Continious
Tone Coded Squelch System) / DCS (Digital Coded Squelch)")
Either CTCSS or DCS can be used but never both at the same time.

13.5 Transmitting a Signal

To check the channel activity use the monitor function (See chapter
"13.8 Monitor").
Twintalker 4810
Battery Full
Battery 2/3 charged
Battery 1/3 charged
Battery empty
• Press the - button
speaker volume. The volume level is displayed.
• Press the - button
• Press and hold the PTT - button
symbol is displayed.
• Hold the unit in a vertical position with the microphone 10cm
from the mouth and speak into the microphone.
• Release the PTT - button
transmitting.
9
in stand-by-mode to increase the
to decrease the speaker volume.
6
11 to transmit. The TX
11
when you want to stop
Twintalker 4810
65