Control Panel - Smeg KDD90VXE Bedienungsanleitung

USE
But Function
ton
The button only works when the door is open.
A
Turns the motor On/Off at speed one.
Press and hold the button for approximately 5 seconds, with
all the loads turned off (Motor and Lights), to turn the
Remote control On/Off.
Press Briefly = Turns the Lights On/Off at maximum intensity.
B
Press and hold for 2 Seconds = Turns the Courtesy Lights On/Off.
The button only works when the door is open.
C
Activates / Deactivates the 24h function which turns the
motor on at speed one for 10 minutes every hour, for 24
hours.
At the end of this time the hood turns Off.
Only works with the Door Open = decreases the operating speed.
D
Speeds P1 - P2 are the 2 intensive speeds, which are set to:
P1 = 5 minutes and P2 = 10 minutes
At the end of this time the motor returns to speed two.
Only works with the Door Open = increases the operating speed.
E
Speeds P1 - P2 are the 2 intensive speeds, which are set to:
P1 = 5 minutes and P2 = 10 minutes
At the end of this time the motor returns to speed two.
Works both with the Door Closed and Open.
Press and hold for 2 Seconds = Enables/Disables the Activated
Charcoal Filter Alarm with the Motor turned off and no Filter
Alarm triggered.
Only works with the Door Open.
F
Activates/Deactivates the Delay, automatic switch-off of the motor
with a 15' delay.
When this function is activated the motor is set to speed one. If the
function is deactivated before the time foreseen, the motor will
remain at speed one.
Works both with the Door Closed and Open.
G
Press and hold for 2 Seconds = With the filter alarm triggered the
Filter Alarm is Reset. These indications are only visible when the
motor is turned off.
Door Closed
H
Opens the door and Motor + Lights = On.
Door Open
Closes the door and Motor + Lights = Off
EN

Control panel

LED button
IR+Dot (Flashes twice)-Remote control On.
IR+Dot (Flashes once)–Remote control Off.
Displays an animation.
Displays the set speed:
P2 – P1 – 3 – 2 – 1
Displays the set speed:
1 – 2 – 3 – P1 – P2
C flashes twice = A.C. Filter Alarm Activated
C flashes once = A.C. Filter Alarm Deactivated
Displays L
Displays
Indicates the need to wash the metal grease filters.
The alarm is triggered after the Hood has been in
operation for 100 working hours.
Displays
Indicates the need to change the activated charcoal
filters, and also to wash the metal grease filters.
The alarm is triggered after the Hood has been in
operation for 200 working hours.
:
3 33