Audio/Video Connection; Handling And Use; Switching On And Off - Silvercrest SKES 2 A1 Bedienungsanleitung

GB
IE
CY

Audio/video connection

Handling and use

Switching on and off
8
■ Do not place the device, furniture or any other objects on the cable. Do not
kink the cable or knot it and do not connect it to other cables. Never wrap
the cable tightly around other objects otherwise the conductors inside the
cable could break and cause a malfunction.
NOTE
► The device can be operated with one or two microphones.
♦ Connect the audio signal for the accompanying music source (e.g. a DVD
player) using one of the supplied audio/video connection cables to the
AUDIO INPUT sockets (L = left channel
accompanying music source only has a SCART output, you can use the
supplied SCART/cinch adapter "OUT"
the adapter and cable connections as an orientation aid.
♦ Connect the video signal of the accompanying music source to the VIDEO
INPUT socket . The video signal is used to display the song lyrics.
♦ Connect the VIDEO OUTPUT socket
allow the singer(s) to read the song lyrics.
♦ Connect the AUDIO OUTPUT sockets of the device (L = left channel
right channel ) either to the audio input of the television or a special ampli-
fi er system (Hi-Fi system, PA, or similar). Using an amplifi er system is sure
to produce a better sound quality. If the television only has a SCART input,
you can use the supplied SCART/cinch adapter "IN"
markings on the adapter and cable connections as an orientation aid.
♦ Connect the supplied microphones
Their signals correspond to the left
This section provides you with important information on handling and using the
device.
After connecting the device to the power supply, press the POWER button
switch on the device. The switch-on control LED
Press the button again to switch off the device. The LED indicator goes out. To
preserve the environment and for reasons of safety, you should disconnect the
mains adapter when the device is not in use.
, R = right channel
. Use the coloured markings on
to the video input of a television to
. Use the coloured
to the inputs MIC1 and MIC2
and right audio outputs.
above the button lights up.
). If the
, R =
.
to
SKES 2 A1