Silvercrest SPU 900 A2 Bedienungsanleitung Seite 13

1. Press and hold the button UP o for two
seconds: The radio alarm searches for the
station with the next highest frequency.
2. Press and hold the button DOWN i for
two seconds: The radio alarm searches for
the station with the next lowest frequency.
Repeat these steps until you have found a
radio station to your liking.
Programming stations
You can save 20 VHF stations for 2 users as
favourites in the appliance. These memory
slots are spread over several pages, which
can be called up via the PAGE button f.
On each page there are 4 Sender slots, they
can be addressed with the PRESET/ALARM
+/-buttons s/d.
1. With the radio switched on, press the
PAGE button f to call up the desired
memory page 1-5. In the display g the
number of the just selected memory page
appears below "PAGE".
2. Tune in to the desired station.
3. Briefly press the button A.M.S. MEMORY
h. In the display g the number and the
memory slot indicator "MEM" blink.
4. Now, using the PRESET/ALARM +/— but-
tons s/d, select the place at which the
radio station is to be saved. Confirm it
with the A.M.S. MEMORY button h. The
radio station is now saved and will be
permanently indicated.
5. As the appliance can be used by several
people, it is equipped with user switching.
Both users can thus save different radio
stations as favourites. To switch over to
the individual user, press and hold the
NAP|USER button k for two seconds.
The currently active user, "A" or "B", is
indicated on the display g.
6. Repeat the steps 1 - 4 (for both users) until
all desired radio stations have been saved.
AMS (Automatic Memory System)
With the AMS function the radio searches au-
tomatically for radio stations and then saves
them to the memory positions.
• Press and hold the button A.M.S. MEM-
ORY h for two seconds. The radio alarm
automatically searches for sufficiently
powerful radio stations and saves them in
the memory.
Accessing the station
1. To recall a saved radio station, in Radio
mode first select the desired user.
2. Now select the required memory page
with the PAGE button f.
3. Using the PRESET/ALARM +/- button s/
d, select the desired memory space for
the radio station.
Adjusting the volume.
• In radio modus, repeatedly press the but-
ton VOL — q to reduce the sound volume.
To the right in the display g the current
sound volume setting is indicated in steps
from V 0 - 18.
• Repeatedly press the button Vol. + w to
increase the sound volume.
Switch-off Timer
This appliance is fitted with a switch-off timer
for up to 90 minutes.
1. Press the button SLEEP j to call the func-
tion up and, if need be, to switch the ra-
dio on.
2. Repeatedly press the button SLEEP j to
enter in the remaining playing time in steps
of 10 minutes. After a few seconds, the
frequency is indicated once again.
3. In the display g the Sleep indicator ap-
pears
4. At any time you can press the SLEEP
button j to blend in the remaining
countdown time for a few seconds.
5. On expiry of the time period the ap-
pliance switches itself off.
6. To switch the timer off prematurely,
press the
Switching and dimming the display
You can adjust the display brightness by
pressing the SNOOZE / DIMMER button y
to one of three settings: bright, medium, off.
- 10 -
.
l button.