Variant A ball adapter
You will need the following accessories to install the rod mount
+
♦
Push the plug connector to ball joint adapter
♦
Unscrew the bolt using the nut.
♦
Put the screw back into the mount and then tighten it again.
♦
Undo the screw cap on the plug connector to ball joint adapter
♦
Push the ball joint on the ball adapter
adapter
.
♦
Retighten the screw cap on the plug connector to ball joint adapter
♦
Place the thread
tight.
NOTE
►
To adjust the camera, undo the screw cap and/or the nut on the plug connector and move
the camera into the required position. Then re-tighten the screw cap and/or the nut on the
plug connector of the rod mount
■
46
GB│IE│NI
│
:
+
into the screw cap on the plug connector to ball joint
on the camera onto the fixture of the ball adapter
.
:
into the socket.
.
.
and screw the camera
SWK 360 A1