Accessories
Using the mounts
The camera is supplied with various mounts which allow the use of the camera different situations.
NOTE
►
You can use a Phillips screwdriver to unscrew all the screws.
Helmet mount
DANGER
►
The double-sided tape
protective effect of the helmet.
NOTE
►
The helmet mount is only suitable for helmets with vents.
You will need the following accessories to install the helmet mount
♦
Undo the screw on the helmet mount
♦
Push the plug connector to ball joint adapter
♦
Put the screw back into the mount and then tighten it again.
♦
Undo the screw cap on the plug connector to ball joint adapter
♦
Push the ball joint on the ball adapter
adapter
.
♦
Retighten the screw cap on the plug connector to ball joint adapter
♦
First guide the strap of the helmet mount
the clamps (see figure 13).
■
40
GB│IE│NI
│
may not be used on a protective helmet as it may impair the
+
and remove it completely from the mount.
into the socket.
into the screw cap on the plug connector to ball joint
through the vents on the helmet and then through
:
+
+
.
.
SWK 360 A1