Ape Labs Apestick Bedienungsanleitung Seite 25

GENERAL SETTINGS
- TRANSMIT MODE:
1. SEND ON MODIFY: transmits changed values immediately
2. SEND ON ENTER: transmits changed values after pushing
the „SEND" button
- SEND TO TYPE: Set of receiving unit by choosing the lamp type
(mobilight, apestick, etc.)
- SEND TO S/N: Set of receiving unit by choosing the serial number
AUTO SETTINGS
- PROGRAM: Select pre-set programs (20)
- INTENSITY: Adjust brightness (0 % - 100 %)
- SPEED: Set speed of program (90 ms - 9.21 min)
- FADE: Set fade time in programs (0% - 100%)
- DIRECTION: Set program direction (forward, backward, repeat)
- USER COLORS: Setting colors used in programs.
- STROBOSCOPE: Push the "BRIGHTNES" button for 2 seconds and
set your strobe value.
INFO
- FIRMWARE VERSION: Firmware version
- RF LINK: type of frequency band
FACTORY RESET (REMOTE CONTROL)
If you are confused about your settings, you can perform a factory reset.
No programs or the like will be deleted, only your personal settings.
FACTORY RESET (APESTICK)
Push the on/off - Button for 10 seconds. Personal settings will be deleted.
ape labs apestick user manual
25